----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Hi Jack; Yes, I have it installed. It is hung with 5/8 inch wide (I used ..050) strips behind the seat and under the hat shelf with # 4 sheet metal screws. The hat shelf is fastened to frame D with screws which go through the canvass and 5/8 strip. The sides are hung from a small angle (I used 1/2 X 1/2 .060) which fastens to the seat back and to frame D under the hat shelf. There should be a sewn in loop all the way around the top of the canvass which the strips and angles go into. I found a picture in the service manual which depicted the "lift the dot" post on the fuselage side behind the battery compartment, so I put them in that way. It took me a while to locate the holes for the sheet metal screws using the original holes, but once I had that done, I put the metal strip inside of the canvass loop and put the screws through it, then it was a piece of cake. I also found that Univair has lots of the original baggage compartment covers, so I have one on the way to finish the installation with. (less than $25) Lynn __________________________________________________ To unsubscribe from this list please send mailto:[EMAIL PROTECTED] ___________________________________________________________ T O P I C A http://www.topica.com/t/17 Newsletters, Tips and Discussions on Your Favorite Topics
<<attachment: winmail.dat>>
