Hi!
I guess it will help if you provide full Curl verbose output for both cases,
otherwise, it is not clear if the resolution was the same.
For example, ares_getaddrinfo() might give IPv6 name resolution vs IPv4 one
when using the old approach.
Interestingly enough, I am not able to duplicate the issue when using
the curl binary any longer; in my initial testing also calling through
the curl binary failed, several recompiles later that is not the case.
Using the unpatched libcurl.so file does still fail my testing binary,
so there might be some setup that differ.
I'm not sure how to do that, sorry.
You can use the CURLOPT_INTERFACE option. It gives the ability to specify the
network interface by IP address.
Setting it to "host!" and the IPv6 address of each interface (2a06...)
gives me a "failed to connect: Error" (28) after a timeout, for all
connections, the same that I get for HTTPS when not specifying. Using
"if!eth0" gives me the same, whereas "if!eth1" does succeed to go
through (with IPv4, I assume). Using "host!" and the IPv4 address of
each interface succeeds.
So, in summary:
iface | host!IPv6 | host!IPv4 | if!name
------+-----------+-----------+---------
eth0 | error | OK | error
eth1 | error | OK | OK
eth2 | error | OK | error
libcurl reports (strerror [CURLcode]: CURL_ERRORBUFFER):
"Error [28]: Failed to connect to license.microanalytics.org port 80 after 15201 ms:
Error"
--
\\// Peter - http://www.softwolves.pp.se/
--
Unsubscribe: https://lists.haxx.se/listinfo/curl-library
Etiquette: https://curl.se/mail/etiquette.html
