Folks, I am clearly doing something wrong here. I have a machine with a wired ethernet connection that I have manually configured the ipv4 address for, it appears to have an ipv6 address:
wm0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 capabilities=7ff80<TSO4,IP4CSUM_Rx,IP4CSUM_Tx,TCP4CSUM_Rx> capabilities=7ff80<TCP4CSUM_Tx,UDP4CSUM_Rx,UDP4CSUM_Tx,TCP6CSUM_Rx> capabilities=7ff80<TCP6CSUM_Tx,UDP6CSUM_Rx,UDP6CSUM_Tx,TSO6> enabled=0 ec_capabilities=7<VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU> ec_enabled=0 address: 74:d0:2b:2b:89:bc media: Ethernet autoselect (1000baseT full-duplex,flowcontrol,rxpause,txpause) status: active inet 192.168.3.1 netmask 0xffffff00 broadcast 192.168.3.255 inet6 fe80::76d0:2bff:fe2b:89bc%wm0 prefixlen 64 scopeid 0x1 but I cannot seem to add a default route for ipv6 to point to my home router. I know my ipv6 set up is ok because a laptop I configure using dhcp works fine with ipv6 so it must be something I am not doing on the wired machine. Any suggestions? Thanks. -- Brett Lymn