Hello, I have three monitors (WinXP Pro): 1 <-> 2 <-> 3
where 2 is the primary monitor (desktop) and 3 is driven by a old PCI based VGA card. 1 & 2 are driven by the same AGP card. When I start an xterm, it always loads on monitor 1 and everything seems to work. When I move that xterm to monitors 2 or 3 it stops repainting (goes white). Wait! You are about to tell me about -multiplemonitors. That works only if I disable monitor 3. If I have extended/activated the monitor 3 desktop repainting on both monitors 2 and 3 is disabled, regardless of the presence of the -multiplemonitor switch. Is this a known problem? Alternatively, does anyone have this configuration working, so I know the fault is my setup, not cygwin? Is there a work around? Another data point: If I disable monitor 3 and start XWin on multiple monitors, it works and both monitors 1 & 2. If I then enable monitor 3, it continues to work on 1 & 2, but not 3. If I start Xwin with all three monitors enabled, only monitor 1 repainting works. Hope that makes sense. - Henrik