Hi Corinna, I am not sure whether this is a 128 k problem. I tested with a file that had 1 MB of data at the beginning and another 1 MB of data at the end. In between there were some 18 MB of zeroes (checked this with a hex-editor).
I produced that file by using eMule for downloading random files. So, I could produce a real sparse file on my NTFS volume which was 20 MB in properties but only occupied 2 MB on my disk. The sparse attribute was properly set as well (checked with fsutil.exe from WinXP) However, even when I tried to copy that file -- which was already "sparse" -- with cp.exe to another folder on the same disk, the sparse attribute was gone and the file now occupied 20 MB of disk space. To me it looks as if neither the copy command for copying already existing sparse files, nor the copy command for producing sparse files from files with "holes" works on Windows NTFS 5.0- Once again, this is the commands I typed in: "cp --sparse=always c:\test.cfg c:\test2.cfg" Hope I sent this mail to the correct address now, because I had some problems with being blacklisted at cygwin.com, at least that's what an autoresponder told me. Cheers for now, Rolf -----Ursprungliche Nachricht----- Von: Corinna Vinschen [mailto:[EMAIL PROTECTED] Gesendet: Mittwoch, 2. Februar 2005 12:21 An: cygwin@cygwin.com Cc: RE Betreff: Re: WG: cp command - problem with sparse [sparse file suuport under NTFS (Win2k)] [Please don't CC me, send everything just to the ML] On Feb 2 11:29, RE wrote: > Hi Corinna, > > Eric Blake send me a mail with a reference to your post > <[EMAIL PROTECTED]> > > Well, I am not a programmer but I am looking for a solution for the > following. And I think that cp.exe from fileutils/coreutils might do the > job. But so far I wasn't successful. > > I have files on my HD that contain large amounts of zeroes (between 4 and > 100 MB of zeroes) and I want to convert them into sparse files. I already > tried the GNU fileutils with their cp command. They say that it converts > standard files into sparse files by using the command > > "cp --sparse=always c:\test.cfg c:\test2.cfg" > > > Everything works fine with that cp command, except the fact that I do not > get a sparse file. Even when I copy a sparse file, the sparse attribute is > no longer present in the copy and the occupied space on my HD is the same as > with the original file. > > What am I doing wrong? Is there a bug with cp.exe? Is the command I am > using not correct? That's something which has to be debugged. Erik, your call. The question is, does cp use lseek to skip over 128K of 0-bits and then simply writes further? What Cygwin does is this, basically: On lseek: did_lseek = true; On write: if (did_lseek) if (current_position > actual_length) if (filesystem supports sparse AND current_position >= actual_length + (128 * 1024)) make_file_sparse If make_file_sparse doesn't work, the strace will have an entry along the lines of 0 = DeviceIoControl(1234, FSCTL_SET_SPARSE, ... Corinna -- Corinna Vinschen Please, send mails regarding Cygwin to Cygwin Project Co-Leader mailto:cygwin@cygwin.com Red Hat, Inc. -- Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple Problem reports: http://cygwin.com/problems.html Documentation: http://cygwin.com/docs.html FAQ: http://cygwin.com/faq/
