dt crashed on me a couple of times while creating many line masks but none of the masks were lost and I was able to continue until all 34 were complete. It happened while creating the masks but not afterwards when I was doing other things and the exports went fine. However, there may also be a limit to these too. The crash is likely related to having 4gb non-upgradeable RAM on the small laptop I take to the cottage so I wouldn't worry about that.
On Thu, Aug 29, 2019 at 2:29 AM Jean-Luc Coulon (f5ibh) < [email protected]> wrote: > Hi, > I also experienced this. > The workaround is to open a second instance of the module. > > Regards > > Jean-Luc > > Le jeu. 29 août 2019 à 06:44, August Schwerdfeger < > [email protected]> a écrit : > >> Recently when editing a dusty film scan I tried to use the "spot removal" >> module to take care of the dust. After adding 64 strokes, I discovered that >> any further strokes were no-ops, producing no visible change to the image >> when added. I then created a second instance of the module; strokes added >> there worked as expected. >> >> Is there an implicit limit of 64 strokes in the "spot removal" module? >> >> -- >> August Schwerdfeger >> [email protected] >> >> ___________________________________________________________________________ >> darktable developer mailing list to unsubscribe send a mail to >> [email protected] >> > > ___________________________________________________________________________ > darktable developer mailing list to unsubscribe send a mail to > [email protected] > ___________________________________________________________________________ darktable developer mailing list to unsubscribe send a mail to [email protected]
