Looks like the problem was caused by some i2c issues we have. the ATA_EN
somehow got disabled prior to the drive mounting.
ken
-----Original Message-----
From: [EMAIL PROTECTED]
To: [email protected]
Sent: Tue, 5 Dec 2006 1:18 PM
Subject: IDE driver changes in v1.1
Does anyone know what the major changes are in the linux IDE driver from the
dvevm, v1.0 to v1.1?
We have a custom board that fails to boot with the kernel from the v1.1 update
with the following errors. reverting to the kernel from v1.0 works fine.
....
hda:DaVinci I2C WARNING: i2c: NACK detected
DaVinci I2C WARNING: i2c: NACK detected
IP-Config: Complete:
device=eth0, addr=192.168.1.165, mask=255.255.255.0, gw=192.168.1.254,
host=dvr01, domain=, nis-domain=(none),
bootserver=192.168.1.254, rootserver=192.168.1.254, rootpath=
status timeout: status=0xff { Busy }
ide: failed opcode was: unknown
hda: DMA disabled
hda: drive not ready for command
ide0: reset timed-out, status=0xff
hda: status timeout: status=0xff { Busy }
ide: failed opcode was: unknown
hda: drive not ready for command
ide0: reset timed-out, status=0xff
end_request: I/O error, dev hda, sector 996032
EXT3-fs: unable to read superblock
end_request: I/O error, dev hda, sector 996032
EXT2-fs: unable to read superblock
end_request: I/O error, dev hda, sector 996030
....
Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading
spam and email virus protection.
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
________________________________________________________________________
Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading spam
and email virus protection.
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
