and what is the appropriate way to set a static ip. I am booting using cramfs, and I need a static address but i've found that the only way to do that is setting ip=<address> and nfsroot=<serveraddress>:/<serverpath>. even though root is set to cramfs. I don't need the nfsroot line b/c nfs isn't used, its just the only way i've found to get the system not to attempt dhcp. when i remove the nfsroot line and i just leave the ip line it still tries to boot via dhcp.
thanx Nachum Kanovsky Senior Software/Hardware Engineer Manager of Infrastructures Mango DSP Ltd. E-mail: [EMAIL PROTECTED] Work: +972 2 588 5039 Cell: +972 547 508 121 Favorite Quote: Mal: "Well, my days of not taking you seriously are certainly coming to a middle..." -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Hunter, Jon Sent: Tuesday, March 06, 2007 4:29 PM To: [EMAIL PROTECTED] Cc: davinci-linux-open-source@linux.davincidsp.com Subject: RE: davinci boot > I boot the board form flash using the root filesystem in hard disk. And I > unplug the network cable. In the course of the boot, > 1 . Sending DHCP request, it will try two times and hold up several minutes. How to skip the procedure. You can skip the DHCP in the boot sequence, by setting the linux kernel boot parameter "ip=off" in the u-boot bootargs. Cheers Jon _______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source _______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
