Hi,
I didnt made both changes at same time. I did one by one, in both the
cases there is no voltage signal at UART1 pins on board.
Had you tried connecting your uart1 DC2 30 and 32 pins to a signal
oscilloscope and check the voltage activity?
Nainawat
Skema (www.skema.fr)
Hardware engineer
Fance.
On 4/26/07, 姜维 < [EMAIL PROTECTED]> wrote:
> Don't make the two changes at the same time..
>
> The driver works well for mine.
>
> If you changed the kernel,don't add the driver;
>
> Or if you add the module,don't change the kernel.
>
> _______________________________________________
> Davinci-linux-open-source mailing list
> [email protected]
> http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
>
>
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
