Hello Eric,
Yes we were able to open the device successfully and get a file handle. We used address 0x56. But the read or write failed with the Remote I/O Error. Also, the I2C_FUNCS returns just a 1, meaning that there are no read/write support? Regards Suba. ----- Original Message ---- From: Eric Tanner <[EMAIL PROTECTED]> To: Subashini Balaraman <[EMAIL PROTECTED]> Sent: Thursday, May 17, 2007 6:49:34 PM Subject: RE: I2C error Did you setup the I2C port with ioctl? After you open the devecice use this to configure what you would like to do with it.. then your reads and rights should be fine.. > > Hello Eric, > > Thanks a lot. We tried the same procedure as your sample. Now we can > access the device. > > During read() or write(), we still get an error: Remote I/O error. > > Any ideas why? > > > Regards > Suba. > > ____________________________________________________________________________________Be a better Globetrotter. Get better travel answers from someone who knows. Yahoo! Answers - Check it out. http://answers.yahoo.com/dir/?link=list&sid=396545469 _______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source