Vladimir, This suggestion sounds good ... I'll check it out here and we'll try to get it into future releases.
Regards, Mugdha -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Vladimir Pantelic Sent: Friday, February 22, 2008 4:39 PM To: [EMAIL PROTECTED] Cc: davinci-linux-open-source@linux.davincidsp.com Subject: Re: DSPLINK: Change output dir of build process Robert W. Kuhn wrote: > Am Fri, 22 Feb 2008 12:15:26 +0530 schrieb Kamoolkar, Mugdha: > >> Currently this is not configurable. The binaries are automatically >> generated in: >> $(DSPLINK)/dsp/export/BIN/$(DSPOS)/$(PLATFORM)/$(VARIANT)/[DEBUG | >> RELEASE] >> >> This is to ensure generic make-system for different platforms & builds. Still it could allow to set a common output path, which will then have the $(PLATFORM)/$(VARIANT)/etc appended too. I would very much like to have the object/binary output generated outside of the source tree, not because I have to copy the final binary somewhere else, but because my whole project builds *outside* of the source tree and dsplink is the only thing that is still in-tree and needs special care.. Regards, Vladimir _______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source _______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
