Am Wed, 05 Mar 2008 17:59:52 +0100 schrieb Dirk Behme:

> -- cut --
> there is a new version of this driver which (I believe) has been
>   submitted to linux-ide.  This should be merged soon.
> -- cut --
> 
> http://linux.omap.com/pipermail/davinci-linux-open-source/2008-February/005182.html

I tried the patch. After disbling sound the evm boots until:
...
Linux video capture interface: v2.00
i2c /dev entries driver
TLV320AIC23 I2C version 1.8 (10-Feb-2006)
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
physmap platform flash device: 01000000 at 02000000
physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
Support for command set 0001 not present
gen_probe: No supported Vendor Command Set found
physmap-flash physmap-flash.0: map_probe failed
mice: PS/2 mouse device common for all mice
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
IP-Config: Guessing netmask 255.255.0.0
IP-Config: Complete:
      device=eth0, addr=172.16.0.2, mask=255.255.0.0, gw=255.255.255.255,
     host=172.16.0.2, domain=, nis-domain=(none),
     bootserver=255.255.255.255, rootserver=255.255.255.255, rootpath=
Root-NFS: No NFS server available, giving up.
VFS: Unable to mount root fs via NFS, trying floppy.
VFS: Cannot open root device "hda1" or unknown-block(2,0)
Please append a correct "root=" boot option; here are the available partitions:
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(2,0)

The env:
DaVinci EVM # printenv
bootdelay=3
bootcmd=setenv setboot setenv bootargs $(bootargs) 
video=dm64xxfb:output=$(videostd);run setboot;bootm 0x2050000
bootfile="uImage_2.6.24"
stdin=serial
stdout=serial
stderr=serial
ethaddr=00:0e:99:02:5c:3e
videostd=pal
ipaddr=172.16.0.2
serverip=172.16.0.1
bootargs=mem=64m console=ttyS0,115200n8 rw noinitrd ip=172.16.0.2 root=/dev/hda1

Environment size: 349/131068 bytes

What could be the problem?
Bye - Robert

_______________________________________________
Davinci-linux-open-source mailing list
Davinci-linux-open-source@linux.davincidsp.com
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source

Reply via email to