-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 David Brownell wrote: > On Monday 02 February 2009, Yusuf Caglar AKYUZ wrote: >> Is it possible to use CF? I haven't seen any references to it. I'm >> desperately searching for info on using CF. Let me ask while I found >> the specialist. > > I was told that it should work OK, if someone provides a bit of glue > code. Basically it uses the IDE driver and runs the CF in "true IDE" > mode ... in my schematics, sheet 28 suggests that most of the setup > can more or less be done at board init time by tweaking existing code: > > - power up the CF slot (talk to the msp430) > - take the CF out of reset (U35 GPIOs) > - select CF instead of ATA (U35 GPIOs again) >
Wow, thanks. This is the kind of information I was looking for. I'll try to implement these. > You could presumably get fancy and make it act like a CF-only PCMCIA > slot, using the card detect logic to do whatever is needed. Once it > works in "true IDE" mode, that is. > I never thought this. I think it worths a try. I hope it's not much of a hack for me, though. Thanks again, Caglar > - Dave > > -----BEGIN PGP SIGNATURE----- Version: GnuPG v2.0.9 (GNU/Linux) Comment: Using GnuPG with SUSE - http://enigmail.mozdev.org iEYEARECAAYFAkmIDBsACgkQ/nL+S5dojegkpgCgh9EFCGcA0ZVroC4epdRGzsKO NgYAoJymZEMJLsELSHhlCeP3HpPKHfMK =YzPQ -----END PGP SIGNATURE----- _______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
