thanks Deepak: I have configed kernel by the command : make ARCH=arm CROSS_COMPILE=arm_v5t_le- davinci_dm355_defconfig make ARCH=arm CROSS_COMPILE=arm_v5t_le- uImage use the default configs for dm355,the kernel can't been boot up,I have Enabled kernel hacking->kernel debuging->low level debug functions. the same result i goted! the envirment is: software:DaVinciLSP_02_00_00_110 ,mvltools5_0_0801921 hardware: dm355 evm and resut is as:
DM355 EVM # tftpboot TFTP from server 10.0.0.89; our IP address is 10.0.0.53 Filename 'uImage'. Load address: 0x80700000 Loading: ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ########################################################### done Bytes transferred = 1965512 (1dfdc8 hex) DM355 EVM # bootm ## Booting image at 80700000 ... Image Name: Linux-2.6.18_pro500-davinci_evm- Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 1965448 Bytes = 1.9 MB Load Address: 80008000 Entry Point: 80008000 Verifying Checksum ... OK OK Starting kernel ... Uncompressing Linux................................................................................................................................... It stoped here for ever! it seems no printed kernel information only uboot prints,I have doubled where the serial configs have errors,I have checked the bootargs whick can been used well for the uImage that comes with DVSDK. setenv bootargs console=ttyS0,115200n8 noinitrd rw ip=dhcp root=/dev/nfs nfsroot=10.0.0.89:/opt/montavista/pro/devkit/arm/v5t_le/target/, nolock mem=116M video=davincifb:vid0=720x576x16,2500K:vid1=720x576x16, 2500K:osd0=720x576x16,2025K davinci_enc_mngr.ch0_output=COMPOSITE davinci_enc_mngr.ch0_mode=$(videostd) so it is not the bootargs error i think! serial driver error? board config driver error? It amazed me so far! 2009-05-15 zuowenping 发件人: Deepak Mundra 发送时间: 2009-05-14 22:46:04 收件人: Steve Chen 抄送: zuowenping; davinci-linux-open-source 主题: Re: I can't boot linux2.6.18 uImage in dm355 Dear zuowenping do make menuconfig Enable kernel hacking->kernel debuging->low level debug functions and compile the kernel and post the kernel output here Regards Deepak On 5/14/09, Steve Chen <sc...@mvista.com> wrote: On Thu, 2009-05-14 at 13:49 +0800, zuowenping wrote: > My develop envirment : > DaVinciLSP_02_00_00_110 ,mvltools5_0_0801921 and dm355 evm > I have built the kernel by reference the pdf " TMS320DM355 DVEVM v1.30 > Getting Started Guide" , > DM355 EVM # printenv > bootdelay=3 > baudrate=115200 > bootfile=uImage > bootcmd=nboot 0x80700000 0 0x400000;bootm 0x80700000 > fileaddr=80700000 > ipaddr=10.0.0.53 > bootargs=console=ttyS0,115200n8 noinitrd rw ip=dhcp root=/dev/nfs > nfsroot=10.0.0.89:/nfs/restore_dm355,nolock mem=116M > video=davincifb:vid0=720x576x16,2500K:vid1=720x576x16, > 2500K:osd0=720x576x16,2025K davinci_enc_mngr.ch0_output=COMPOSITE > davinci_enc_mngr.ch0_mode=pal > serverip=10.0.0.89 > filesize=2191c0 > stdin=serial > stdout=serial > stderr=serial > videostd=pal > > Environment size: 491/16380 bytes > why not success? > Any clues will be appreciated! Just want to make sure I understand, you can boot the board with the binary that comes with DVSDK, but you can not boot the board with the binary generated by following the "Getting Started Guide" If that is the case, what are the commands you used to configure and build the kernel and what error did you see during boot up? Regards, Steve _______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
_______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source