On Fri, Aug 21, 2009 at 6:14 AM, Theo Debrouwere <[email protected]>wrote:
> linghai624 wrote: > >> Hi, >> I followed the wiki >> http://wiki.davincidsp.com/index.php/Linux_Toolchain to make uImage : >> make distclean, >> make davinci_evm_dm644x_defconfig or make davinci_evm_all_defconfig >> (I have tried both) >> make uImage >> make modules >> and my compiler toolchain is CodeSourcery G++ 4.3-234, but the uboot >> can't start the uImage completely on dm6446 evm ! All information is >> followed >> > > [snip] > > eth0: attached PHY driver [LXT971] (mii_bus:phy_addr=1:01, id=1378e2) >> IP-Config: Complete: >> device=eth0, addr=192.168.55.28, mask=255.255.255.0, gw=192.168.55.1, >> host=192.168.55.28, domain=, nis-domain=(none), >> bootserver=192.168.55.61, rootserver=192.168.55.61, rootpath= >> Looking up port of RPC 100003/2 on 192.168.55.61 >> PHY: 1:01 - Link is Up - 100/Full >> Looking up port of RPC 100005/1 on 192.168.55.61 >> VFS: Mounted root (nfs filesystem) on device 0:13. >> Freeing init memory: 112K >> >> >> then it stop here , please help me ! >> > > Afaik, your kernel did start correctly. So no uboot issue. > > It appears you mounted your filesystem over nfs. > Is this filesystem correct? Or did you leave it empty? > > You need > /dev/console > /dev/tty > Nodes. > > And you need a link to the program you want to boot. > /init or /linuxrc (depending on your config) > > (Often a softlink to busybox.) > > Also, make sure you have a > /etc/inittab > & something in this file. > > Regards > > Theo > > > DISCLAIMER: > Unless indicated otherwise, the information contained in this message is > privileged and confidential, and is intended only for the use of the > addressee(s) named above and others who have been specifically authorized to > receive it. If you are not the intended recipient, you are hereby notified > that any dissemination, distribution or copying of this message and/or > attachments is strictly prohibited. The company accepts no liability for any > damage caused by any virus transmitted by this email. Furthermore, the > company does not warrant a proper and complete transmission of this > information, nor does it accept liability for any delays. If you have > received this message in error, please contact the sender and delete the > message. Thank you. > > > _______________________________________________ > Davinci-linux-open-source mailing list > [email protected] > http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source > You may also have a problem if your kernel is compiled with CONFIG_AEABI switched the wrong way. I wasted several hours on a similar problem. --jc
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
