All, Any comments/suggestions on this patch?
Regards, Chaithrika On Tue, Oct 20, 2009 at 15:48:07, Chaithrika U S wrote: > The clock divider value can be calculated from the pixel clock > value for the panel. This gives more flexiblity to the driver > to change the divider value on the fly as in the case of cpufreq > feature- support for which will be added shortly. > > Signed-off-by: Chaithrika U S <chaithr...@ti.com> > --- > This patch applies on Linus' kernel tree. > Resending this patch as missed out marking fbdev list previously. > > drivers/video/da8xx-fb.c | 28 ++++++++++++++++++++-------- > 1 files changed, 20 insertions(+), 8 deletions(-) > > diff --git a/drivers/video/da8xx-fb.c b/drivers/video/da8xx-fb.c > index d065894..d9ab839 100644 > --- a/drivers/video/da8xx-fb.c > +++ b/drivers/video/da8xx-fb.c > @@ -113,6 +113,7 @@ struct da8xx_fb_par { > unsigned short pseudo_palette[16]; > unsigned int databuf_sz; > unsigned int palette_sz; > + unsigned int pxl_clk; > }; > > /* Variable Screen Information */ > @@ -155,7 +156,7 @@ struct da8xx_panel { > int vfp; /* Vertical front porch */ > int vbp; /* Vertical back porch */ > int vsw; /* Vertical Sync Pulse Width */ > - int pxl_clk; /* Pixel clock */ > + unsigned int pxl_clk; /* Pixel clock */ > unsigned char invert_pxl_clk; /* Invert Pixel clock */ > }; > > @@ -171,7 +172,7 @@ static struct da8xx_panel known_lcd_panels[] = { > .vfp = 2, > .vbp = 2, > .vsw = 0, > - .pxl_clk = 0x10, > + .pxl_clk = 4608000, > .invert_pxl_clk = 1, > }, > /* Sharp LK043T1DG01 */ > @@ -185,7 +186,7 @@ static struct da8xx_panel known_lcd_panels[] = { > .vfp = 2, > .vbp = 2, > .vsw = 10, > - .pxl_clk = 0x12, > + .pxl_clk = 7833600, > .invert_pxl_clk = 0, > }, > }; > @@ -451,6 +452,18 @@ static void lcd_reset(struct da8xx_fb_par *par) > lcdc_write(0, LCD_RASTER_CTRL_REG); > } > > +static void lcd_calc_clk_divider(struct da8xx_fb_par *par) > +{ > + unsigned int lcd_clk, div; > + > + lcd_clk = clk_get_rate(par->lcdc_clk); > + div = lcd_clk / par->pxl_clk; > + > + /* Configure the LCD clock divisor. */ > + lcdc_write(LCD_CLK_DIVISOR(div) | > + (LCD_RASTER_MODE & 0x1), LCD_CTRL_REG); > +} > + > static int lcd_init(struct da8xx_fb_par *par, const struct lcd_ctrl_config > *cfg, > struct da8xx_panel *panel) > { > @@ -459,9 +472,8 @@ static int lcd_init(struct da8xx_fb_par *par, const > struct lcd_ctrl_config *cfg, > > lcd_reset(par); > > - /* Configure the LCD clock divisor. */ > - lcdc_write(LCD_CLK_DIVISOR(panel->pxl_clk) | > - (LCD_RASTER_MODE & 0x1), LCD_CTRL_REG); > + /* Calculate the divider */ > + lcd_calc_clk_divider(par); > > if (panel->invert_pxl_clk) > lcdc_write((lcdc_read(LCD_RASTER_TIMING_2_REG) | > @@ -721,6 +733,8 @@ static int __init fb_probe(struct platform_device *device) > } > > par = da8xx_fb_info->par; > + par->lcdc_clk = fb_clk; > + par->pxl_clk = lcdc_info->pxl_clk; > > if (lcd_init(par, lcd_cfg, lcdc_info) < 0) { > dev_err(&device->dev, "lcd_init failed\n"); > @@ -753,8 +767,6 @@ static int __init fb_probe(struct platform_device *device) > da8xx_fb_fix.smem_len = par->databuf_sz - par->palette_sz; > da8xx_fb_fix.line_length = (lcdc_info->width * lcd_cfg->bpp) / 8; > > - par->lcdc_clk = fb_clk; > - > par->irq = platform_get_irq(device, 0); > if (par->irq < 0) { > ret = -ENOENT; > -- > 1.5.6 > _______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source