Hi All,
We are seeing following problem: Setup: We have connected a USB hub to DVEVM. We have connected two bulk devices mass storage and USB wireless device. We are continuously receiving data on USB wireless device (using iperf utility) and at the same time continuously writing to mass storage device. We do fsync () after writing data using write command to ensure data is actually written to mass storage device. Problem statement: In above setup we see SCSI errors and I/O errors. Also we have observed "usb 1-1.1: usb_sg_cancel, unlink --> 0" message sometimes. What is the significance of this message? Has anyone tested USB driver in such a driver? Regards, Pratik Joshi Embedded Engineer eInfochips Ltd, Ahmedabad, India +91-079-26563705 - ext - 303 www.einfochips.com -- _____________________________________________________________________ Disclaimer: This e-mail message and all attachments transmitted with it are intended solely for the use of the addressee and may contain legally privileged and confidential information. If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution, copying, or other use of this message or its attachments is strictly prohibited. If you have received this message in error, please notify the sender immediately by replying to this message and please delete it from your computer. Any views expressed in this message are those of the individual sender unless otherwise stated.Company has taken enough precautions to prevent the spread of viruses. However the company accepts no liability for any damage caused by any virus transmitted by this email. _____________________________________________________________________
_______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source