From: Murali Karicheri <m-kariche...@ti.com>

Add binding documentation for spi-davinci module.

[prakash...@ti.com: Follow DT naming convention for compatible property]
Signed-off-by: Murali Karicheri <m-kariche...@ti.com>
Reviewed-by: Grant Likely <grant.lik...@secretlab.ca>
Reviewed-by: Sekhar Nori <nsek...@ti.com>
Signed-off-by: Manjunathappa, Prakash <prakash...@ti.com>
---
Since v3:
Changed the commit message and fixed alignment issues.

 .../devicetree/bindings/spi/spi-davinci.txt        |   51 ++++++++++++++++++++
 1 files changed, 51 insertions(+), 0 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/spi/spi-davinci.txt

diff --git a/Documentation/devicetree/bindings/spi/spi-davinci.txt 
b/Documentation/devicetree/bindings/spi/spi-davinci.txt
new file mode 100644
index 0000000..6d0ac8d
--- /dev/null
+++ b/Documentation/devicetree/bindings/spi/spi-davinci.txt
@@ -0,0 +1,51 @@
+Davinci SPI controller device bindings
+
+Required properties:
+- #address-cells: number of cells required to define a chip select
+       address on the SPI bus. Should be set to 1.
+- #size-cells: should be zero.
+- compatible:
+       - "ti,dm6441-spi" for SPI used similar to that on DM644x SoC family
+       - "ti,da830-spi" for SPI used similar to that on DA8xx SoC family
+- reg: Offset and length of SPI controller register space
+- num-cs: Number of chip selects
+- ti,davinci-spi-intr-line: interrupt line used to connect the SPI
+       IP to the interrupt controller within the SoC. Possible values
+       are 0 and 1. Manual says one of the two possible interrupt
+       lines can be tied to the interrupt controller. Set this
+       based on a specifc SoC configuration.
+- interrupts: interrupt number mapped to CPU.
+- clocks: spi clk phandle
+
+Example of a NOR flash slave device (n25q032) connected to DaVinci
+SPI controller device over the SPI bus.
+
+spi0:spi@20BF0000 {
+       #address-cells                  = <1>;
+       #size-cells                     = <0>;
+       compatible                      = "ti,dm6446-spi";
+       reg                             = <0x20BF0000 0x1000>;
+       num-cs                          = <4>;
+       ti,davinci-spi-intr-line        = <0>;
+       interrupts                      = <338>;
+       clocks                          = <&clkspi>;
+
+       flash: n25q032@0 {
+               #address-cells = <1>;
+               #size-cells = <1>;
+               compatible = "st,m25p32";
+               spi-max-frequency = <25000000>;
+               reg = <0>;
+
+               partition@0 {
+                       label = "u-boot-spl";
+                       reg = <0x0 0x80000>;
+                       read-only;
+               };
+
+               partition@1 {
+                       label = "test";
+                       reg = <0x80000 0x380000>;
+               };
+       };
+};
-- 
1.7.4.1

_______________________________________________
Davinci-linux-open-source mailing list
Davinci-linux-open-source@linux.davincidsp.com
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source

Reply via email to