Hi I'm running an PC164SX , using milo to boot my kernel, which was working fine when I used a 4.5 Gb scsi harddisk.
Now I have put in a 18 Gb scsi disk and milo fails to load the kernel from that disk , or read the filesystems on it. It gives errors indicating it does not recognize the (ext2) filesystem. (BTW I can load a milo off a FAT filesystem on the 18 Gb disk) When I boot the kernel from the 4.5 Gb disk , but use the 18 Gb disk for / , it's all fine. All filesystems check are OK. So once the kernel is running it has no problem with the 18 Gb disk at all. I've tried the newer milo's for my system , all have the same behavior. I use ARC BIOS. The scsi-controller is an AHA2940UW but that should not be a problem since the 4.5 Gb disk boots off it fine. Does anyone know off anything to try before I start converting to srm/aboot ? (Which I'm not to happy about, as it involves flashing , repartioning disks....) All hints are appreciated ! Jaap. --------------------------------------------------------------------------- This message (including any attachments) is confidential and may be privileged. If you have received it by mistake please notify the sender by return e-mail and delete this message from your system. Any unauthorised use or dissemination of this message in whole or in part is strictly prohibited. Please note that e-mails are susceptible to change. ABN AMRO Bank N.V. (including its group companies) shall not be liable for the improper or incomplete transmission of the information contained in this communication nor for any delay in its receipt or damage to your system. ABN AMRO Bank N.V. (or its group companies) does not guarantee that the integrity of this communication has been maintained nor that this communication is free of viruses, interceptions or interference. ---------------------------------------------------------------------------
