On Mon, Aug 29, 2005 at 07:45:33PM +0100, Rupert Heesom wrote: > I seem to be having problems when configuring my disk setup during the > net install for sarge amd64. > > I'm trying to configure /home to be an MD within an LVM container. > Although the install can configure it, when I've rebooted the install, > and installed evms, then it seems the LVM container has the wrong MD in it.
Normally you setup an MD raid to run LVM on top of. I normally do this: /sda1 /sdb1 128M md0 raid1 ext2 /boot /sda2 /sdb2 10G md1 raid1 ext3 / /sda3 /sdb3 lots md2 raid1 PV for LVM LVM then contains stuff like 20G /home, 2G swap, giant /data and whatever else I need. I could probably conbine / and /boot now that grub seems to support md raid1. > Without going into further details, has anyone else tried to configure > an MD within an LVM using the amd64 install? > > I'm wondering about using EVMS to reconfigure the /home LVM container > that was created at install. EVMS is something else entirely and does not (last I checked) work with the standard LVM in the kernel which is what the debian installer sets up. > Also how do those using MD (raid1) handle the SWAP partition? Do you > leave the 2 partitions that would be used for an MD seperate and use > each one for swap space, or do you use an MD for swap space? I run swap in an LVM logical volume. Len Sorensen -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]