---------- Forwarded message ---------- From: Craig Hagerman <[EMAIL PROTECTED]> Date: Jan 10, 2006 5:30 PM Subject: Re: lm_sensors package To: Lennart Sorensen <[EMAIL PROTECTED]>
Thanks for all the advice. I have things solved and will report on what I have done. Did an apt-get install lm-sensors and then recompiled the kernel. sensors-detect told me that it needed modules for: eeprom smbus-arp w83627hf I already had i2c stuff compiled as modules but didn't have the eeprom module. I enabled that (device drivers > I2C support > miscellaneous i2c chip support). I am not exactly sure where the other two are. The only thing I found that looked like smbus-arp (subus I think) said it was experimental and not recommended. Hmmm... what to do? I didn't enable that. Likewise, I am not sure where to enable the w83627hf modules, but under device drivers > Harware Monitoring Support there are 5 Winbond modules that sound similar. I built all of them as modules. Later I did: modprobe eeprom modprobe w83627hf and both worked! (I was expecting the later to fail, but apparently one of those winbond modules IS the right one.) And not sensors does give me a report: $ sensors w83627thf-isa-0290 Adapter: ISA adapter VCore: +1.50 V (min = +0.00 V, max = +3.84 V) +12V: +11.43 V (min = +8.03 V, max = +0.00 V) +3.3V: +3.26 V (min = +1.54 V, max = +0.45 V) +5V: +4.99 V (min = +3.41 V, max = +4.19 V) -12V: -14.91 V (min = -14.91 V, max = -14.91 V) V5SB: +5.00 V (min = +1.83 V, max = +0.00 V) VBat: +0.21 V (min = +3.84 V, max = +0.27 V) fan1: 0 RPM (min = 1350000 RPM, div = 1) CPU Fan: 2205 RPM (min = -1 RPM, div = 4) fan3: 0 RPM (min = 79411 RPM, div = 1) M/B Temp: +30 C (high = +2 C, hyst = +8 C) sensor = thermistor CPU Temp: +41.5 C (high = +80 C, hyst = +75 C) sensor = thermistor temp3: +20.0 C (high = +80 C, hyst = +75 C) sensor = thermistor vid: +0.300 V (VRM Version 8.2) alarms: beep_enable: Sound alarm enabled