Greetings! This is regarding my post on SD/MMC on the PB-ARM926EJ-S:
http://www.spinics.net/lists/arm-kernel/msg28535.html I would like to know if anyone is using the SD/MMC on this versatile PB-ARM926EJ-S board with linux 2.6.12. I have enabled the options here in the kernel .config: [*] MMC Support [ ] MMC debugging [*] MMC block device driver [*] ARM AMBA Multimeda Card Interface support [ ] Winbond W83L51xD SD/MMC Card Interface support The mmc driver gets loaded as seen in the output mentioned in the above link. The FPGAs that get mapped are, fpga:5 and fpga:a, fpga:b. In /proc/devices I see 254 registered with mmc. There is /dev/mmc already in base.cramfs filesystem provided by ARM, but, do we need to mount it? I have a Sandisk 256 MB CF which I place in the MMC slot, but, I don't see any detection or relevant output in dmesg. There is a mmc0, mmc1 displayed in dmesg with address, irq details. Is this relevant? Do the above mentioned drivers compiled in the kernel sufficient to use the SD/MMC interface? Or do we have to write our own drivers? Any help in this regard is appreciated. Thanks, K Shakthi ------------------------------------------------------------ Shakthi Kannan, MS Software Engineer, Specsoft (Hexaware Technologies) [E]: [EMAIL PROTECTED] [M]: (91) 98407-87007 [W]: http://www.shakthimaan.com [L]: Chennai, India ------------------------------------------------------------ ____________________________________________________ Start your day with Yahoo! - make it your home page http://www.yahoo.com/r/hs -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]