On Saturday 10 November 2007 18:51, you wrote: > * Thomas Winter <[EMAIL PROTECTED]> [2007-11-10 18:34]: > > am running debian etch on Thecus N2100 with one SATA disk. I tried > > to add an second SATA, but Thecus did not boot, nothing in syslog. > > > > Any trick to add an second hard disk? > > Hard to tell without any logs, but I guess the box tried to mount root > on the wrong disk and failed. Remove the 2nd drive again, and update > /etc/fstab to use UUID. Read section "The slug fails to reboot with 2 > drives connected" at http://www.nslu2-linux.org/wiki/Debian/TroubleShooting > for some instructions. (This is for the Linksys NSLU2 but the same > applies to the Thecus N2100.)
thanks, that could be the case I tried #update-initramfs -u I got this message /boot/initrd.img-2.6.18-4-iop32x has been altered. Cannot update. # aptitude upgrade The following packages have been kept back: linux-image-2.6-iop32x Also Iam concerned that if I change to uuid and the hard disk goes defect I can not change to another hard disk. Can I expect that serial console is working? I did not solder an connector to the pcb until now and did not test. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
