En/na Gaudenz Steinlin ha escrit:
On Fri, Aug 29, 2008 at 03:33:48PM +0200, Xan wrote:
En/na Gaudenz Steinlin ha escrit:
Okay. Thanks.
With ifconfig -a, it appears. But I have two new interfaces. How can I
see what modules use any of these?
ifconfig -a eth0 Link encap:Ethernet HWaddr 00:18:39:8a:77:7e
inet addr:172.26.0.2 Bcast:172.26.255.255 Mask:255.255.0.0
inet6 addr: fe80::218:39ff:fe8a:777e/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1298 errors:0 dropped:0 overruns:0 frame:0
TX packets:1015 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:98030 (95.7 KiB) TX bytes:218310 (213.1 KiB)
lo Link encap:Local Loopback inet addr:127.0.0.1
Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:8 errors:0 dropped:0 overruns:0 frame:0
TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:560 (560.0 B) TX bytes:560 (560.0 B)
wlan0 Link encap:Ethernet HWaddr 00:80:5a:4e:29:3d
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)a
This is the wireless interface. You have to use this one for all
operations.
wmaster0 Link encap:UNSPEC HWaddr
00-80-5A-4E-29-3D-02-00-00-00-00-00-00-00-00-00 BROADCAST
MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
What is ralink: wmaster0 or wlan0. Why I have two new interfaces?
The wmaster0 interface is an internal interface created by the linux
wireless stack. Just ignore it for all normal operations.
Gaudenz
Thanks a lot,
Xan.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
Ok. Thanks a lot, Gaudenz.
Last question: how can I see what module wlan0 is used? rt2x00 or rt73?
Regards,
Xan.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]