Package: installation-reports Debian-installer-version: Not sure about date, but it's the beta 2 installer from the Debian website uname -a: Linux localhost 2.4.22-1-386 #9 Sat Oct 4 14:30:39 EST 2003 i686 GNU/Linux Date: 14:30 (GMT-5) February 3, 2004 Method: Booted off the 100mb CD image for i386. Rest of install was through FTP from the ftp://ftp.uwsg.indiana.edu/linux/debian/ mirror. No proxy, other than the NAT. At least, not that I know of.
Machine: Dell Precision 650 Processor: dual 2.4Ghz Xeon Memory: 1gb Root Device: 04:0e.0 SCSI storage controller: LSI Logic / Symbios Logic 53c1030 PCI-X Fusion-MPT Dual Ultra320 SCSI (rev 07) scsibus0: 0,0,0 0) 'SEAGATE ' 'ST373453LW ' 'DX10' Disk Root Size/partition table: Disk /dev/sda: 73.4 GB, 73407820800 bytes 255 heads, 63 sectors/track, 8924 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/sda1 1 5 40131 de Dell Utility /dev/sda2 6 332 2626627+ b W95 FAT32 /dev/sda3 * 333 345 104422+ 83 Linux /dev/sda4 346 8924 68910817+ f W95 Ext'd (LBA) /dev/sda5 346 8670 66870531 83 Linux /dev/sda6 8671 8924 2040223+ 82 Linux swap /dev/sda3 = /boot /dev/sda5 = / /dev/sda6 = swap other partitions ignored Output of lspci: 00:00.0 Host bridge: Intel Corp. E7505 Memory Controller Hub (rev 03) 00:01.0 PCI bridge: Intel Corp. E7000 Series Processor to AGP Controller (rev 03) 00:02.0 PCI bridge: Intel Corp. E7000 Series Hub Interface B PCI-to-PCI Bridge (rev 03) 00:1d.0 USB Controller: Intel Corp. 82801DB USB (Hub #1) (rev 01) 00:1d.1 USB Controller: Intel Corp. 82801DB USB (Hub #2) (rev 01) 00:1d.2 USB Controller: Intel Corp. 82801DB USB (Hub #3) (rev 01) 00:1d.7 USB Controller: Intel Corp. 82801DB USB2 (rev 01) 00:1e.0 PCI bridge: Intel Corp. 82801BA/CA/DB/EB PCI Bridge (rev 81) 00:1f.0 ISA bridge: Intel Corp. 82801DB LPC Interface Controller (rev 01) 00:1f.1 IDE interface: Intel Corp. 82801DB Ultra ATA Storage Controller (rev 01)00:1f.3 SMBus: Intel Corp. 82801DB/DBM SMBus Controller (rev 01) 01:00.0 VGA compatible controller: nVidia Corporation NV18GL [Quadro4 NVS AGP 8x] (rev a2) 02:1c.0 PIC: Intel Corp. 82870P2 P64H2 I/OxAPIC (rev 04) 02:1d.0 PCI bridge: Intel Corp. 82870P2 P64H2 Hub PCI Bridge (rev 04) 02:1e.0 PIC: Intel Corp. 82870P2 P64H2 I/OxAPIC (rev 04) 02:1f.0 PCI bridge: Intel Corp. 82870P2 P64H2 Hub PCI Bridge (rev 04) 03:0e.0 Ethernet controller: Intel Corp. 82545EM Gigabit Ethernet Controller (Copper) (rev 01) 04:0e.0 SCSI storage controller: LSI Logic / Symbios Logic 53c1030 PCI-X Fusion-MPT Dual Ultra320 SCSI (rev 07) 05:0c.0 FireWire (IEEE 1394): Texas Instruments TSB43AB22/A IEEE-1394a-2000 Controller (PHY/Link) 05:0e.0 Ethernet controller: Linksys Network Everywhere Fast Ethernet 10/100 model NC100 (rev 11) Base System Installation Checklist: Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [ ] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [O] Reboot: [O] [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Comments/Problems: The step of configuring my /etc/apt/sources.list never believed it had completed successfully. Once I edited it by hand, I discovered that it was inserting a new set of correct lines each time I attempted to configure it from the GUI, but even hand editing didn't convince the system that it had completed the step. Once I just skipped ahead to installing things, it went fine. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]