This is probably not in the domain of the installer but I'm not sure where to report this.
Following the installation, I assigned a static IP address on the LAN to set the box up as a server. All works fine. However, if I pull the power supply and plug it back in, the machine recovers fine except that eth0 doesn't come up; if I reboot the machine eth0 comes up fine and ifconfig shows everything as normal. After the reboot 'tail dmesg' shows: EXT3 FS on dm-1, internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS on dm-2, internal journal EXT3-fs: mounted filesystem with ordered data mode. Adding 2330616k swap on /dev/mapper/Saturn-swap_1. Priority:-1 extents:1 across:2330616k eth0: link up, 100Mbps, full-duplex, lpa 0x45E1 NET: Registered protocol family 10 lo: Disabled Privacy Extensions IPv6 over IPv4 tunneling driver After the power interruption 'tail dmesg.0' shows: kjournald starting. Commit interval 5 seconds EXT3 FS on dm-4, internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS on dm-1, internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS on dm-2, internal journal EXT3-fs: mounted filesystem with ordered data mode. Adding 2330616k swap on /dev/mapper/Saturn-swap_1. Priority:-1 extents:1 across:2330616k Can you suggest anything I could try? Thanks Clive -- www.clivemenzies.co.uk ... ...strategies for business -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]