Hi, this is the dmesg output if the machine boots correctly. If an "out-of-scan-range" occours, none of it gets displayed, I just can see some lines for maybe a second when the kernel gets loaded and unpacked - then the monitor fades away...
regards,
Holger
Total memory = 256MB; using 512kB for hash table (at c0300000)
Linux version 2.6.8-powerpc ([EMAIL PROTECTED]) (gcc version 3.3.4 (Debian
1:3.3.4-11)) #1 Sun Oct 3 13:22:21 CEST 2004
PCI bus 0 controlled by pci at 80000000
PCI bus 0 controlled by pci at c0000000
Pegasos l2cr : L2 cache was not active, activating
On node 0 totalpages: 65536
DMA zone: 65536 pages, LIFO batch:16
Normal zone: 0 pages, LIFO batch:1
HighMem zone: 0 pages, LIFO batch:1
Built 1 zonelists
Kernel command line: root=/dev/hda5
PID hash table entries: 2048 (order 11: 16384 bytes)
time_init: decrementer frequency = 33.333333 MHz
Console: colour dummy device 80x25
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Memory: 251072k available (1732k kernel code, 1084k data, 164k init, 0k
highmem)
Calibrating delay loop... 665.60 BogoMIPS
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
checking if image is initramfs...it isn't (no cpio magic); looks like an
initrd
Freeing initrd memory: 4669k freed
NET: Registered protocol family 16
PCI: Probing PCI hardware
radeonfb: Found Intel x86 BIOS ROM Image
radeonfb: No ATY,RefCLK property !
radeonfb: Retreived PLL infos from BIOS
radeonfb: Reference=27.00 MHz (RefDiv=12) Memory=200.00 Mhz, System=166.00 MHz
radeonfb: Monitor 1 type CRT found
radeonfb: EDID probed
radeonfb: Monitor 2 type no found
EDID checksum failed, aborting
EDID checksum failed, aborting
radeonfb: ATI Radeon Yd DDR SGRAM 128 MB
Thermal assist unit not available
audit: initializing netlink socket (disabled)
audit(): initialized
devfs: 2004-01-31 Richard Gooch ([EMAIL PROTECTED])
devfs: boot_options: 0x0
Initializing Cryptographic API
Console: switching to colour frame buffer device 80x30
Generic RTC Driver v1.07
Macintosh non-volatile memory driver v1.1
Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled
ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
pmac_zilog: 0.6 (Benjamin Herrenschmidt <[EMAIL PROTECTED]>)
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
divert: not allocating divert_blk for non-ethernet device lo
input: Macintosh mouse button emulation
Warning: no ADB interface detected
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
mice: PS/2 mouse device common for all mice
NET: Registered protocol family 2
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 32768)
RAMDISK: Compressed image found at block 0
VFS: Mounted root (cramfs filesystem) readonly.
Freeing unused kernel memory: 164k init 60k pmac 32k prep
NET: Registered protocol family 1
VP_IDE: IDE controller at PCI slot 0000:00:0c.1
VP_IDE: chipset revision 6
VP_IDE: VIA vt8231 (rev 10) IDE UDMA100 controller on pci0000:00:0c.1
VP_IDE: 100% native mode on irq 14
ide0: BM-DMA at 0x1020-0x1027, BIOS settings: hda:pio, hdb:pio
ide1: BM-DMA at 0x1028-0x102f, BIOS settings: hdc:pio, hdd:pio
Probing IDE interface ide0...
hda: ST340014A, ATA DISK drive
Unhandled interrupt e, disabled
Using anticipatory io scheduler
ide0 at 0x1000-0x1007,0x100e on irq 14
Probing IDE interface ide1...
hdc: SAMSUNG CDRW/DVD SM-352B, ATAPI CD/DVD-ROM drive
Unhandled interrupt f, disabled
ide1 at 0x1010-0x1017,0x101e on irq 15
hda: max request size: 1024KiB
hda: 78165360 sectors (40020 MB) w/2048KiB Cache, CHS=16383/255/63, UDMA(100)
/dev/ide/host0/bus0/target0/lun0: RDSK p1 p2 p3 p4 p5 p6 p7 p8
EXT3-fs: INFO: recovery required on readonly filesystem.
EXT3-fs: write access will be enabled during recovery.
kjournald starting. Commit interval 5 seconds
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
Adding 1027836k swap on /dev/hda4. Priority:-1 extents:1
EXT3 FS on hda5, internal journal
serio: i8042 AUX port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
input: AT Translated Set 2 keyboard on isa0060/serio0
hdc: ATAPI 52X DVD-ROM CD-R/RW drive, 2048kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.20
input: ImExPS/2 Logitech Explorer Mouse on isa0060/serio1
ts: Compaq touchscreen protocol output
ieee1394: Initialized config rom entry `ip1394'
SCSI subsystem initialized
sbp2: $Rev: 1219 $ Ben Collins <[EMAIL PROTECTED]>
ohci1394: $Rev: 1223 $ Ben Collins <[EMAIL PROTECTED]>
PCI: Enabling device 0000:00:01.0 (0000 -> 0003)
ohci1394: fw-host0: OHCI-1394 1.0 (PCI): IRQ=[9] MMIO=[80000000-800007ff]
Max Packet=[2048]
MV-64340 10/100/1000 Ethernet Driver
MV-64340: Chip base remaped at 0xd225b000
divert: allocating divert_blk for eth0
eth0: port 1 with MAC address 00:...
RX TCP/UDP Checksum Offload ON,
TX and RX Interrupt Coalescing ON
RX NAPI Enabled
via-rhine.c:v1.10-LK1.1.20-2.6 May-23-2004 Written by Donald Becker
PCI: Enabling device 0000:00:0d.0 (0000 -> 0003)
divert: allocating divert_blk for eth1
eth1: VIA Rhine II at 0x80000800, 00:..., IRQ 9.
eth1: MII PHY found at address 16, status 0x786d advertising 01e1 Link 45e1.
ieee1394: Host added: ID:BUS[0-00:1023] GUID[]
ip1394: $Rev: 1224 $ Ben Collins <[EMAIL PROTECTED]>
divert: not allocating divert_blk for non-ethernet device eth2
ip1394: eth2: IEEE-1394 IPv4 over 1394 Ethernet (fw-host0)
usbcore: registered new driver usbfs
usbcore: registered new driver hub
USB Universal Host Controller Interface driver v2.2
PCI: Enabling device 0000:00:0c.2 (0000 -> 0001)
uhci_hcd 0000:00:0c.2: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1
Controller
uhci_hcd 0000:00:0c.2: irq 9, io base 00001040
uhci_hcd 0000:00:0c.2: new USB bus registered, assigned bus number 1
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
PCI: Enabling device 0000:00:0c.3 (0000 -> 0001)
uhci_hcd 0000:00:0c.3: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1
Controller (#2)
uhci_hcd 0000:00:0c.3: irq 9, io base 00001060
uhci_hcd 0000:00:0c.3: new USB bus registered, assigned bus number 2
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
PCI: Enabling device 0000:00:0c.5 (0000 -> 0001)
eth1: Setting full-duplex based on MII #16 link partner capability of 45e1.
NET: Registered protocol family 17
ip_tables: (C) 2000-2002 Netfilter core team
ip_conntrack version 2.1 (2048 buckets, 16384 max) - 296 bytes per conntrack
nfs warning: mount version older than kernel
nfs warning: mount version older than kernel
NET: Registered protocol family 10
Disabled Privacy Extensions on device c02393c4(lo)
IPv6 over IPv4 tunneling driver
divert: not allocating divert_blk for non-ethernet device sit0
eth1: no IPv6 routers present
[drm] Initialized radeon 1.11.0 20020828 on minor 0: ATI Technologies Inc
RV280 [Radeon 9200 SE]
[drm] Loading R200 Microcode
[drm] Loading R200 Microcode
pgpI1wARf90ZC.pgp
Description: PGP signature
