On Fri, 20 Aug 2004, jlquinn wrote: > Attempting to put an IBM T41p to sleep does not work. The following > chunk of kernel log shows why: > > Aug 20 03:10:09 localhost kernel: e1000: eth0: e1000_watchdog: NIC Link > is Up 100 Mbps Full D > uplex > Aug 20 03:10:12 localhost kernel: PM: Preparing system for suspend > Aug 20 03:10:17 localhost kernel: Stopping tasks: > =========================================== > =============================| > Aug 20 03:10:17 localhost kernel: PCI: Setting latency timer of device > 0000:00:1d.7 to 64 > Aug 20 03:10:17 localhost kernel: Could not suspend device 0000:00:1d.7: > error -5 > Aug 20 03:10:17 localhost kernel: PCI: Enabling device 0000:00:1f.5 > (0000 -> 0003) > Aug 20 03:10:17 localhost kernel: i810_audio: Primary codec has ID 0 > Aug 20 03:10:17 localhost kernel: ac97_codec: AC97 Audio codec, id: > ADS116 (Unknown) > Aug 20 03:10:17 localhost kernel: PCI: Setting latency timer of device > 0000:00:1f.6 to 64 > Aug 20 03:10:17 localhost kernel: Restarting tasks... done > Aug 20 03:10:17 localhost kernel: apm: BIOS version 1.2 Flags 0x03 > (Driver version 1.16ac) > Aug 20 03:10:17 localhost kernel: apm: overridden by ACPI. > Aug 20 03:10:19 localhost kernel: e1000: eth0: e1000_watchdog: NIC Link is Up > 100 Mbps Full Duplex > > Device 1d.7 according to lspci -vvv is as follows: > > 0000:00:1d.7 USB Controller: Intel Corp. 82801DB/DBM (ICH4/ICH4-M) USB > 2.0 EHCI Controller (rev 01) (prog-if20 [EHCI]) > Subsystem: IBM: Unknown device 052e > Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- > Stepping- SERR+ FastB2B- > Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- > <TAbort- <MAbort- >SERR- <PERR- > Latency: 0 > Interrupt: pin D routed to IRQ 11 > Region 0: Memory at c0000000 (32-bit, non-prefetchable) [size=1K] > Capabilities: [50] Power Management version 2 > Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA > PME(D0+,D1-,D2-,D3hot+,D3cold+) > Status: D0 PME-Enable- DSel=0 > DScale=0 PME- > Capabilities: [58] #0a [2080] > >
does the latest kernel-image 2.6.10 from unstable work for your t41? thanks for your feedback. -- maks -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
