martin f krafft wrote:
also sprach Dan Phillips <[EMAIL PROTECTED]> [2007.05.09.1713 +0200]:
The machine refused to suspend due to unrecognised hardware
without the -f switch. With the -f switch it suspends, but same
problem on resume. This behaviour is the same with or without
Xserver running. The machine just wakes up on resume but the
screen is completely black, no back light, artefacts - nothing.
However, life is there. I can still shut-down by pressing the
power button for example.
Have you tried turning all the Vbe options off?
Have you tried
Runi915resolution yes and no
and is i915resolution installed?
I did not have i915resolution installed and have seen some success
stories on google with this. It is installed now, I just need to know if
the ram.conf is read when running "s2ram -f"? If I run hibernate-ram it
will fall over with unsupported hardware now because it is using s2ram
(uswsusp) but I cannot pass the -f switch. Running s2ram -f suspends,
but has the same problem (but is ram.conf being used with this method)?
There seem to be many methods of suspend. There are 2 options in the
ram.conf: sysfs-ram and ususpend-ram. Both are set to be tried. It is a
little confusing what script or method the machine uses at any one time.
As a workaround to the above I un-installed uswsusp and ran
hibernate-ram with /etc/hibernate/ram.conf set with Runi915resolution
yes and had the same problem. The Vbe options were commented out.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
