Hi,
I'm basically having the same problem (same segfault), but I can't find the
correct way to configure my X server with the new intel driver.
In fact I'm using two very different video cards for my xinerama setup: one
i845G (driver intel) and one old Matrox Mystique (driver mga). I couldn't
find any information about the new configuration with this type of setup, so
I would appreciate a lot to get some help for this issue.
Here is an excerpt of my new xorg.conf (I removed the sections about the
keyboard and DRI) :
Section "Device"
Identifier "matrox"
Driver "mga"
BusID "PCI:1:0:0"
EndSection
Section "Device"
Identifier "Intel"
Driver "intel"
BusID "PCI:0:2:0"
EndSection
Section "Screen"
Identifier "Default Screen"
Device "Intel"
DefaultDepth 16
SubSection "Display"
Depth 24
Virtual 2048 2048
EndSubSection
SubSection "Display"
Depth 16
Virtual 2048 2048
EndSubSection
EndSection
I tried using two Device lines in my Screen section, and got some weird
results; I tried with using +xinerama when starting the server, or without.
I must say I could make it work in "two independant screens" mode (only the
screen on the matrox card was a bit weird, but I suspect I'll have to try a
preferred mode for that).
Here is the relevant part of my old xorg.conf
Section "Device"
Identifier "Intel Corporation 82845G/GL[Brookdale-G]/GE Chipset
Integrated Graphics Device"
Driver "intel"
BusID "PCI:0:2:0"
EndSection
Section "Device"
Identifier "Matrox Mystique"
Driver "mga"
BusID "PCI:1:0:0"
EndSection
Section "Monitor"
Identifier "Philips 170S"
Option "DPMS"
Gamma 0.8
EndSection
Section "Monitor"
Identifier "NEC MultiSync FE950+"
Option "DPMS"
HorizSync 30-96
VertRefresh 50-160
EndSection
Section "Screen"
Identifier "Default Screen"
Device "Intel Corporation 82845G/GL[Brookdale-G]/GE Chipset
Integrated Graphics Device"
Monitor "Philips 170S"
DefaultDepth 16
Lots of SubSection "Display"
EndSection
Section "Screen"
Identifier "Second Screen"
Device "Matrox Mystique"
Monitor "NEC MultiSync FE950+"
DefaultDepth 16
Lots of SubSection "Display"
EndSection
Section "ServerLayout"
Identifier "Default Layout"
Screen "Default Screen"
Screen "Second Screen" RightOf "Default Screen"
InputDevice "Generic Keyboard"
InputDevice "Configured Mouse"
EndSection
And I used to start X with the +xinerama option.
Thanks for having read until this ;)
Regards,
--
Julien Wajsberg
