Hi Christian, Christian Kastner wrote, on 20-03-10 03:44: > have you encountered this issue again since your initial report, or is > it still unreproducible?
I tested the boot process with three different zd1211 devices and the boot process did not slow down as much as it did. See the attached document for more information. I believe the problem has been fixed somewhere. (any idea where?) Thanks in advance, Kind regards, Jelle de Jong
$ uname -a Linux mini01 2.6.30-2-686 #1 SMP Fri Dec 4 00:53:20 UTC 2009 i686 GNU/Linux $ cat /proc/cmdline BOOT_IMAGE=/boot/vmlinuz-2.6.30-2-686 root=UUID=7234a43e-c3d9-41e3-8cc6-837d36da273e ro rootfstype=ext4 ipv6.disable=1 quiet # device01 $ tail -n 200 /var/log/kern.log Mar 20 12:19:04 mini01 kernel: [ 486.120097] usb 1-7: new high speed USB device using ehci_hcd and address 9 Mar 20 12:19:04 mini01 kernel: [ 486.253628] usb 1-7: New USB device found, idVendor=0586, idProduct=3410 Mar 20 12:19:04 mini01 kernel: [ 486.253641] usb 1-7: New USB device strings: Mfr=16, Product=32, SerialNumber=0 Mar 20 12:19:04 mini01 kernel: [ 486.253651] usb 1-7: Product: ZyXEL G-202 Mar 20 12:19:04 mini01 kernel: [ 486.253658] usb 1-7: Manufacturer: ZyDAS Mar 20 12:19:04 mini01 kernel: [ 486.253930] usb 1-7: configuration #1 chosen from 1 choice Mar 20 12:19:04 mini01 kernel: [ 486.372086] usb 1-7: reset high speed USB device using ehci_hcd and address 9 Mar 20 12:19:04 mini01 kernel: [ 486.507546] phy2: Selected rate control algorithm 'minstrel' Mar 20 12:19:04 mini01 kernel: [ 486.508798] zd1211rw 1-7:1.0: phy2 Mar 20 12:19:04 mini01 kernel: [ 486.546512] udev: renamed network interface wlan0 to wlan1 Mar 20 12:19:04 mini01 kernel: [ 486.568446] usb 1-7: firmware: requesting zd1211/zd1211b_ub Mar 20 12:19:04 mini01 kernel: [ 486.647126] usb 1-7: firmware: requesting zd1211/zd1211b_uphr Mar 20 12:19:04 mini01 kernel: [ 486.727988] zd1211rw 1-7:1.0: firmware version 4725 Mar 20 12:19:05 mini01 kernel: [ 486.770922] zd1211rw 1-7:1.0: zd1211b chip 0586:3410 v4810 high 00-19-cb AL2230_RF pa0 g--NS Mar 20 12:19:05 mini01 kernel: [ 486.773680] cfg80211: Calling CRDA for country: DE Mar 20 12:19:39 mini01 kernel: [ 521.026059] wlan1: authenticate with AP 00:90:4c:91:00:01 Mar 20 12:19:39 mini01 kernel: [ 521.028410] wlan1: authenticated Mar 20 12:19:39 mini01 kernel: [ 521.028423] wlan1: associate with AP 00:90:4c:91:00:01 Mar 20 12:19:39 mini01 kernel: [ 521.030265] wlan1: RX AssocResp from 00:90:4c:91:00:01 (capab=0x431 status=0 aid=2) Mar 20 12:19:39 mini01 kernel: [ 521.030275] wlan1: associated # device02 $ tail -n 200 /var/log/kern.log Mar 20 12:24:27 mini01 kernel: [ 84.460067] usb 1-7: new high speed USB device using ehci_hcd and address 9 Mar 20 12:24:27 mini01 kernel: [ 84.593534] usb 1-7: New USB device found, idVendor=0ace, idProduct=1215 Mar 20 12:24:27 mini01 kernel: [ 84.593547] usb 1-7: New USB device strings: Mfr=16, Product=32, SerialNumber=0 Mar 20 12:24:27 mini01 kernel: [ 84.593557] usb 1-7: Product: USB2.0 WLAN Mar 20 12:24:27 mini01 kernel: [ 84.593564] usb 1-7: Manufacturer: ZyDAS Mar 20 12:24:27 mini01 kernel: [ 84.593840] usb 1-7: configuration #1 chosen from 1 choice Mar 20 12:24:27 mini01 kernel: [ 84.712083] usb 1-7: reset high speed USB device using ehci_hcd and address 9 Mar 20 12:24:28 mini01 kernel: [ 84.847967] phy1: Selected rate control algorithm 'minstrel' Mar 20 12:24:28 mini01 kernel: [ 84.849392] zd1211rw 1-7:1.0: phy1 Mar 20 12:24:28 mini01 kernel: [ 84.966162] udev: renamed network interface wlan0 to wlan4 Mar 20 12:24:28 mini01 kernel: [ 84.978904] usb 1-7: firmware: requesting zd1211/zd1211b_ub Mar 20 12:24:28 mini01 kernel: [ 85.021982] usb 1-7: firmware: requesting zd1211/zd1211b_uphr Mar 20 12:24:28 mini01 kernel: [ 85.145409] zd1211rw 1-7:1.0: firmware version 4725 Mar 20 12:24:28 mini01 kernel: [ 85.185421] zd1211rw 1-7:1.0: zd1211b chip 0ace:1215 v4810 high 00-19-e0 UW2453_RF pa0 -7--- Mar 20 12:24:28 mini01 kernel: [ 85.188874] cfg80211: Calling CRDA for country: DE Mar 20 12:24:43 mini01 kernel: [ 100.106333] wlan4: authenticate with AP 00:90:4c:91:00:01 Mar 20 12:24:43 mini01 kernel: [ 100.113802] wlan4: authenticated Mar 20 12:24:43 mini01 kernel: [ 100.113812] wlan4: associate with AP 00:90:4c:91:00:01 Mar 20 12:24:43 mini01 kernel: [ 100.115540] wlan4: RX AssocResp from 00:90:4c:91:00:01 (capab=0x431 status=0 aid=3) Mar 20 12:24:43 mini01 kernel: [ 100.115550] wlan4: associated Mar 20 12:24:44 mini01 kernel: [ 101.135304] padlock: VIA PadLock not detected. # device03 Mar 20 12:32:10 mini01 kernel: [ 547.756081] usb 1-7: new high speed USB device using ehci_hcd and address 10 Mar 20 12:32:11 mini01 kernel: [ 547.889582] usb 1-7: New USB device found, idVendor=0ace, idProduct=1215 Mar 20 12:32:11 mini01 kernel: [ 547.889596] usb 1-7: New USB device strings: Mfr=16, Product=32, SerialNumber=0 Mar 20 12:32:11 mini01 kernel: [ 547.889606] usb 1-7: Product: USB2.0 WLAN Mar 20 12:32:11 mini01 kernel: [ 547.889613] usb 1-7: Manufacturer: ZyDAS Mar 20 12:32:11 mini01 kernel: [ 547.889880] usb 1-7: configuration #1 chosen from 1 choice Mar 20 12:32:11 mini01 kernel: [ 548.008091] usb 1-7: reset high speed USB device using ehci_hcd and address 10 Mar 20 12:32:11 mini01 kernel: [ 548.143560] phy2: Selected rate control algorithm 'minstrel' Mar 20 12:32:11 mini01 kernel: [ 548.144982] zd1211rw 1-7:1.0: phy2 Mar 20 12:32:11 mini01 kernel: [ 548.188913] udev: renamed network interface wlan0 to wlan3 Mar 20 12:32:11 mini01 kernel: [ 548.231503] usb 1-7: firmware: requesting zd1211/zd1211b_ub Mar 20 12:32:11 mini01 kernel: [ 548.255130] usb 1-7: firmware: requesting zd1211/zd1211b_uphr Mar 20 12:32:11 mini01 kernel: [ 548.400701] zd1211rw 1-7:1.0: firmware version 4725 Mar 20 12:32:11 mini01 kernel: [ 548.441693] zd1211rw 1-7:1.0: zd1211b chip 0ace:1215 v4810 high 00-1a-ee MAXIM_NEW_RF pa0 -7--- Mar 20 12:32:11 mini01 kernel: [ 548.445329] cfg80211: Calling CRDA for country: DE Mar 20 12:32:23 mini01 kernel: [ 560.434272] wlan3: authenticate with AP 00:90:4c:91:00:01 Mar 20 12:32:23 mini01 kernel: [ 560.444515] wlan3: authenticated Mar 20 12:32:23 mini01 kernel: [ 560.444528] wlan3: associate with AP 00:90:4c:91:00:01 Mar 20 12:32:23 mini01 kernel: [ 560.446227] wlan3: RX AssocResp from 00:90:4c:91:00:01 (capab=0x431 status=0 aid=1) Mar 20 12:32:23 mini01 kernel: [ 560.446237] wlan3: associated
