On 29 September 2010 21:18, أحمد المحمودي <aelmahmo...@sabily.org> wrote: > On Wed, Feb 11, 2004 at 09:33:11AM +0100, Tomasz Wegrzanowski wrote: >> The tutorial (/usr/share/doc/gnucap/gnucap-tutorial.gz) constantly >> mentions `acs' instead of `gnucap', but that's not a major problem. > > This part is a duplicate of bug #398810 > >> When you run this example, you might try: >> >> acs eg3.ckt >> >> And (all going well) you will see that node 2 is equivalent to a >> source of 54.343 volts in series with an 0.83888 ohm resistor. >> You should also notice that acs never goes into interactive command mode. >> >> gnucap seems to ignore all the .commands. >> Is that a bug in gnucap or a conciously introduced change of behaviour that >> just wasn't mentioned in the tutorial ? >> >> How to get gnucap run commands non-interactively ? > > I cannot reproduce this problem with gnucap 0.35, please note that in > interactive mode, you should *not* precede the commands with a dot (.)
Are you asking me about bug report I filled in 2004? I haven't used gnucap in ages. -- To UNSUBSCRIBE, email to debian-bugs-dist-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org