Package: installation-reports Severity: grave Boot method: netboot Image version: daily build 2006-12-27, http://people.debian.org/~ths/d-i/mips/images/daily/sb1-bcm91250a/netboot/
Date: 2006-12-29 Machine: Broadcom BCM91250a "SWARM", mips/big-endian mode, 256MB RAM, serial console, IDE disk Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot: [E] Detect network card: [ ] Configure network: [ ] Detect CD: [ ] Load installer modules: [ ] Detect hard drives: [ ] Partition hard drives: [ ] Install base system: [ ] Clock/timezone setup: [ ] User/password setup: [ ] Install tasks: [ ] Install boot loader: [ ] Overall install: [ ] Comments/Problems: ================== Sibyl (the bootloader) starts, loads the kernel and the initrd, jumps into the kernel and the system freezes. Boot log: ========= CFE> boot -tftp 192.168.2.14:/tftpboot/swarm-daily/sibyl Loader:raw Filesys:tftp Dev:eth0 File:192.168.2.14:/tftpboot/swarm-daily/sibyl Options:(null) Loading: ....... 130116 bytes read Entry at 0x0000000020000000 Closing network. Starting program at 0x0000000020000000 SiByte Loader, version 2.4.2 Built on Oct 4 2005 Network device 'eth0' configured Getting configuration file tftp:192.168.2.14:/tftpboot/swarm-daily/sibyl.conf... Config file retrieved. Available configurations: install rescue Boot which configuration [install]: Loading kernel (ELF64): [EMAIL PROTECTED] done Loading ramdisk at 0x8057e000...3622876 bytes loaded Set up command line arguments to: root=/dev/ram console=duart0 ramdisk_size=3576 rd_start=0x8057E000 rd_size=0x3747DC Setting up initial prom_init arguments Cleaning up state... Transferring control to the kernel. Kernel entry point is at 0x804f7000 Broadcom SiByte BCM1250 B2 @ 800 MHz (SB1 rev 2) Board type: SiByte BCM91250A (SWARM) Regards, Karsten -- #include <standard_disclaimer> Nach Paragraph 28 Abs. 3 Bundesdatenschutzgesetz widerspreche ich der Nutzung oder Uebermittlung meiner Daten fuer Werbezwecke oder fuer die Markt- oder Meinungsforschung. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]