Do anyone of you where the proper place to discuss open hardware is? I am going to start a project to replace plc's.
My initial toughts is to use tools like kicad, xfig and git. It will use eurocards (100x160mm) in a standard 3U 19" card cage with DIN 41612 connectors, a backplane with spi-bus, all cards should use double sided printed board (so anyone can make them) -- unless someone else have a better idea. http://wiki.emqbit.com/free-ecb-at91 looks interesting as a starting point for the cpu card. Unfortunately they are using orcad. And yes, I like to use emdebian on it, but we are not there yet. Regards, /Karl ----------------------------------------------------------------------- Karl Hammar Aspö Data k...@aspodata.se Lilla Aspö 148 Networks S-742 94 Östhammar +46 173 140 57 Computers Sweden +46 70 511 97 84 Consulting ----------------------------------------------------------------------- -- To UNSUBSCRIBE, email to debian-embedded-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org