Hi Mark, I have test your script but my woody give me this response:
morpheo:~# cat compartir2 echo 1 > /proc/sys/net/ipv4/ip_forward echo 1 > /proc/sys/net/ipv4/conf/eth0/rp_filter echo 1 > /proc/sys/net/ipv4/conf/eth1/rp_filter iptables -t nat -I POSTROUTING -s 192.168.0.0/24 -i eth1 -o eth0 -j MASQUERADE morpheo:~# ./compartir2 modprobe: Can't locate module ip_tables iptables v1.2.6a: can't initialize iptables table `nat': iptables who? (do you need to insmod?) Perhaps iptables or your kernel needs to be upgraded. morpheo:~# What can i do to solve this new issue? My fisrt script which use ipchains was this: morpheo:~# cat compartir echo 1 > /proc/sys/net/ipv4/ip_forward /sbin/ipchains -P forward DENY /sbin/ipchains -A forward -j MASQ -s 192.168.0.0/16 Thanks in advance, ----- Original Message ----- From: "MB" <[EMAIL PROTECTED]> To: "Francisco Castillo" <[EMAIL PROTECTED]>; <debian-isp@lists.debian.org> Sent: Monday, June 28, 2004 9:16 PM Subject: Re: nat ipchains on debian woody Have you tried iptables instead? If your kernel supports iptables, then: echo 1 > /proc/sys/net/ipv4/ip_forward echo 1 > /proc/sys/net/ipv4/conf/$both_eth_devs/rp_filter iptables -t nat -I POSTROUTING -s 192.168.0.0/24 -i eth1 -o eth0 -j MASQUERADE iptables also does the firewalling in other chains, btw Mark --- Francisco Castillo <[EMAIL PROTECTED]> wrote: > > Hello Gurus, > > I have installed a debian woody with to interfaces eth0 and eth1. I > has configured the internet conexion on eth0 which has got a static > ip on internet. And on eth1 i want to put a interface to do a proxy > nat gateway on my internal lan (i want to put a 192.168.0.1 on it). > > I have read doc to do it but when i apply this doc i have a "your > kernel seems to not support ipchains" messages when i try to do this. > After this i have a 192.168.0.1 ip on eth1 but my pc´s on the > internal lan can´t have internet access througth the eth0 (internet > conexion). > > I think that the problem is that the kernel do not have a > ipmasquerade support (NAT suppport), so i think that this is the only > steep i need to do in order to apply correct the steps of the > configuration that i has a problem with. So > > Did you know how to give a NAT (ipmasquerade support) on a debian > woody kernel in order to solve my problem? > > What do exactly the command "apt-get install ipmasq" in this context > ? > > Thanks in advance, > > Francisco. > >