"Wim van der Meer" <[EMAIL PROTECTED]> writes: > What you have here is a Q&A and it doesn't give any specific > information about the DIP switch functions, except for switch 2-4 > which is labeled as "initialize status switch". The questions that > are answered are basically to solve various kind of problems with > the autoloader.
Ahh, ok. > Did you try to contact Aiwa directly for a proper manual? A lot of > Japanese makers have English manuals as well. Can't hurt to try. Yep. I contacted Aiwa US and Aiwa Japan, along with several companies that repair/support tape loaders with no luck, though Aiwa Japan was quite helpful, going as far as to call me back in response to an email. Unfortunately this tape loader is a several years old, and while that might not normally be a problem, Aiwa shut down their tape drive division a while back and don't seem to have kept a lot of legacy stuff left lying around. In any case, thanks very much. I'll just have to decide if I want to rely on a drive I don't know a lot about :> -- Rob Browning rlb @defaultvalue.org, @linuxdevel.com, and @debian.org Previously @cs.utexas.edu GPG=1C58 8B2C FB5E 3F64 EA5C 64AE 78FE E5FE F0CB A0AD
