Hi, this is the dmesg output if the machine boots correctly. If an "out-of-scan-range" occours, none of it gets displayed, I just can see some lines for maybe a second when the kernel gets loaded and unpacked - then the monitor fades away...
regards, Holger Total memory = 256MB; using 512kB for hash table (at c0300000) Linux version 2.6.8-powerpc ([EMAIL PROTECTED]) (gcc version 3.3.4 (Debian 1:3.3.4-11)) #1 Sun Oct 3 13:22:21 CEST 2004 PCI bus 0 controlled by pci at 80000000 PCI bus 0 controlled by pci at c0000000 Pegasos l2cr : L2 cache was not active, activating On node 0 totalpages: 65536 DMA zone: 65536 pages, LIFO batch:16 Normal zone: 0 pages, LIFO batch:1 HighMem zone: 0 pages, LIFO batch:1 Built 1 zonelists Kernel command line: root=/dev/hda5 PID hash table entries: 2048 (order 11: 16384 bytes) time_init: decrementer frequency = 33.333333 MHz Console: colour dummy device 80x25 Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 251072k available (1732k kernel code, 1084k data, 164k init, 0k highmem) Calibrating delay loop... 665.60 BogoMIPS Mount-cache hash table entries: 512 (order: 0, 4096 bytes) checking if image is initramfs...it isn't (no cpio magic); looks like an initrd Freeing initrd memory: 4669k freed NET: Registered protocol family 16 PCI: Probing PCI hardware radeonfb: Found Intel x86 BIOS ROM Image radeonfb: No ATY,RefCLK property ! radeonfb: Retreived PLL infos from BIOS radeonfb: Reference=27.00 MHz (RefDiv=12) Memory=200.00 Mhz, System=166.00 MHz radeonfb: Monitor 1 type CRT found radeonfb: EDID probed radeonfb: Monitor 2 type no found EDID checksum failed, aborting EDID checksum failed, aborting radeonfb: ATI Radeon Yd DDR SGRAM 128 MB Thermal assist unit not available audit: initializing netlink socket (disabled) audit(): initialized devfs: 2004-01-31 Richard Gooch ([EMAIL PROTECTED]) devfs: boot_options: 0x0 Initializing Cryptographic API Console: switching to colour frame buffer device 80x30 Generic RTC Driver v1.07 Macintosh non-volatile memory driver v1.1 Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A pmac_zilog: 0.6 (Benjamin Herrenschmidt <[EMAIL PROTECTED]>) RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize divert: not allocating divert_blk for non-ethernet device lo input: Macintosh mouse button emulation Warning: no ADB interface detected Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx mice: PS/2 mouse device common for all mice NET: Registered protocol family 2 IP: routing cache hash table of 2048 buckets, 16Kbytes TCP: Hash tables configured (established 16384 bind 32768) RAMDISK: Compressed image found at block 0 VFS: Mounted root (cramfs filesystem) readonly. Freeing unused kernel memory: 164k init 60k pmac 32k prep NET: Registered protocol family 1 VP_IDE: IDE controller at PCI slot 0000:00:0c.1 VP_IDE: chipset revision 6 VP_IDE: VIA vt8231 (rev 10) IDE UDMA100 controller on pci0000:00:0c.1 VP_IDE: 100% native mode on irq 14 ide0: BM-DMA at 0x1020-0x1027, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0x1028-0x102f, BIOS settings: hdc:pio, hdd:pio Probing IDE interface ide0... hda: ST340014A, ATA DISK drive Unhandled interrupt e, disabled Using anticipatory io scheduler ide0 at 0x1000-0x1007,0x100e on irq 14 Probing IDE interface ide1... hdc: SAMSUNG CDRW/DVD SM-352B, ATAPI CD/DVD-ROM drive Unhandled interrupt f, disabled ide1 at 0x1010-0x1017,0x101e on irq 15 hda: max request size: 1024KiB hda: 78165360 sectors (40020 MB) w/2048KiB Cache, CHS=16383/255/63, UDMA(100) /dev/ide/host0/bus0/target0/lun0: RDSK p1 p2 p3 p4 p5 p6 p7 p8 EXT3-fs: INFO: recovery required on readonly filesystem. EXT3-fs: write access will be enabled during recovery. kjournald starting. Commit interval 5 seconds EXT3-fs: recovery complete. EXT3-fs: mounted filesystem with ordered data mode. Adding 1027836k swap on /dev/hda4. Priority:-1 extents:1 EXT3 FS on hda5, internal journal serio: i8042 AUX port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 input: AT Translated Set 2 keyboard on isa0060/serio0 hdc: ATAPI 52X DVD-ROM CD-R/RW drive, 2048kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.20 input: ImExPS/2 Logitech Explorer Mouse on isa0060/serio1 ts: Compaq touchscreen protocol output ieee1394: Initialized config rom entry `ip1394' SCSI subsystem initialized sbp2: $Rev: 1219 $ Ben Collins <[EMAIL PROTECTED]> ohci1394: $Rev: 1223 $ Ben Collins <[EMAIL PROTECTED]> PCI: Enabling device 0000:00:01.0 (0000 -> 0003) ohci1394: fw-host0: OHCI-1394 1.0 (PCI): IRQ=[9] MMIO=[80000000-800007ff] Max Packet=[2048] MV-64340 10/100/1000 Ethernet Driver MV-64340: Chip base remaped at 0xd225b000 divert: allocating divert_blk for eth0 eth0: port 1 with MAC address 00:... RX TCP/UDP Checksum Offload ON, TX and RX Interrupt Coalescing ON RX NAPI Enabled via-rhine.c:v1.10-LK1.1.20-2.6 May-23-2004 Written by Donald Becker PCI: Enabling device 0000:00:0d.0 (0000 -> 0003) divert: allocating divert_blk for eth1 eth1: VIA Rhine II at 0x80000800, 00:..., IRQ 9. eth1: MII PHY found at address 16, status 0x786d advertising 01e1 Link 45e1. ieee1394: Host added: ID:BUS[0-00:1023] GUID[] ip1394: $Rev: 1224 $ Ben Collins <[EMAIL PROTECTED]> divert: not allocating divert_blk for non-ethernet device eth2 ip1394: eth2: IEEE-1394 IPv4 over 1394 Ethernet (fw-host0) usbcore: registered new driver usbfs usbcore: registered new driver hub USB Universal Host Controller Interface driver v2.2 PCI: Enabling device 0000:00:0c.2 (0000 -> 0001) uhci_hcd 0000:00:0c.2: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller uhci_hcd 0000:00:0c.2: irq 9, io base 00001040 uhci_hcd 0000:00:0c.2: new USB bus registered, assigned bus number 1 hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected PCI: Enabling device 0000:00:0c.3 (0000 -> 0001) uhci_hcd 0000:00:0c.3: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (#2) uhci_hcd 0000:00:0c.3: irq 9, io base 00001060 uhci_hcd 0000:00:0c.3: new USB bus registered, assigned bus number 2 hub 2-0:1.0: USB hub found hub 2-0:1.0: 2 ports detected PCI: Enabling device 0000:00:0c.5 (0000 -> 0001) eth1: Setting full-duplex based on MII #16 link partner capability of 45e1. NET: Registered protocol family 17 ip_tables: (C) 2000-2002 Netfilter core team ip_conntrack version 2.1 (2048 buckets, 16384 max) - 296 bytes per conntrack nfs warning: mount version older than kernel nfs warning: mount version older than kernel NET: Registered protocol family 10 Disabled Privacy Extensions on device c02393c4(lo) IPv6 over IPv4 tunneling driver divert: not allocating divert_blk for non-ethernet device sit0 eth1: no IPv6 routers present [drm] Initialized radeon 1.11.0 20020828 on minor 0: ATI Technologies Inc RV280 [Radeon 9200 SE] [drm] Loading R200 Microcode [drm] Loading R200 Microcode
pgp3UxmLHDOQq.pgp
Description: PGP signature