On Thu, Sep 09, 2004 at 03:01:50AM +0200, Nikolaus Schulz wrote: > Package: kernel-image-2.6.8-powerpc > Version: 2.6.8-3 > Severity: important > > Hello, > > > booting kernel 2.6.8 on my iBook 2.2 with a Radeon Mobility M7, the
I also have a Ibook 2.2, the 12" G3/800Mhz one, from february 2003 or thereabout, altough i had the motherboard changed earlier this year due to the infamous ibook motherboard defect. Radeonfb on 2.6.8-4 works just fine with the debian kernel, as you can see in the attached dmesg output, so really i don't understand what is your problem. Do you perhaps have a second monitor or a TV device attached, or maybe do you have some hardware defect that makes the radeon chip think something is bad ? Friendly, Sven Luther
Total memory = 640MB; using 2048kB for hash table (at c0400000) Linux version 2.6.8-powerpc ([EMAIL PROTECTED]) (gcc version 3.3.4 (Debian 1:3.3.4-9)) #1 Mon Aug 30 21:34:45 CEST 2004 Found UniNorth memory controller & host bridge, revision: 192 Mapped at 0xfdf00000 Found a Pangea mac-io controller, rev: 0, mapped at 0xfde80000 Processor NAP mode on idle enabled. PowerMac motherboard: iBook 2 rev. 2 Found UniNorth PCI host bridge at 0xf0000000. Firmware bus number: 0->0 Found UniNorth PCI host bridge at 0xf2000000. Firmware bus number: 0->0 Found UniNorth PCI host bridge at 0xf4000000. Firmware bus number: 0->0 via-pmu: Server Mode is disabled PMU driver 2 initialized for Core99, firmware: 0c nvram: Checking bank 0... nvram: gen0=1064, gen1=1063 nvram: Active bank is: 0 nvram: OF partition at 0x410 nvram: XP partition at 0x1020 nvram: NR partition at 0x1120 On node 0 totalpages: 163840 DMA zone: 163840 pages, LIFO batch:16 Normal zone: 0 pages, LIFO batch:1 HighMem zone: 0 pages, LIFO batch:1 Built 1 zonelists Kernel command line: root=/dev/hda9 ro PowerMac using OpenPIC irq controller at 0x80040000 OpenPIC Version 1.2 (4 CPUs and 64 IRQ sources) at fc62f000 OpenPIC timer frequency is 4.160000 MHz PID hash table entries: 4096 (order 12: 32768 bytes) GMT Delta read from XPRAM: 0 minutes, DST: off time_init: decrementer frequency = 24.835213 MHz Console: colour dummy device 80x25 serial8250_console_init: nothing to do on PowerMac Dentry cache hash table entries: 131072 (order: 7, 524288 bytes) Inode-cache hash table entries: 65536 (order: 6, 262144 bytes) Memory: 638912k available (1720k kernel code, 1108k data, 164k init, 0k highmem) AGP special page: 0xe7fff000 Calibrating delay loop... 1585.15 BogoMIPS Mount-cache hash table entries: 512 (order: 0, 4096 bytes) checking if image is initramfs...it isn't (ungzip failed); looks like an initrd Freeing initrd memory: 4812k freed NET: Registered protocol family 16 PCI: Probing PCI hardware Registering openpic with sysfs... PCI: Enabling device 0000:00:10.0 (0086 -> 0087) radeonfb: Invalid ROM signature 0 should be 0xaa55 radeonfb: Retreived PLL infos from Open Firmware radeonfb: Reference=27.00 MHz (RefDiv=12) Memory=180.00 Mhz, System=180.00 MHz radeonfb: Monitor 1 type LCD found radeonfb: EDID probed radeonfb: Monitor 2 type no found radeonfb: Power Management enabled for Mobility chipsets Registered "ati" backlight controller, level: 15/15 radeonfb: ATI Radeon LW DDR SGRAM 32 MB Thermal assist unit using timers, shrink_timer: 2000 jiffies Registering PowerMac CPU frequency driver Low: 400 Mhz, High: 800 Mhz, Boot: 800 Mhz audit: initializing netlink socket (disabled) audit(1094712365.377:0): initialized devfs: 2004-01-31 Richard Gooch ([EMAIL PROTECTED]) devfs: boot_options: 0x0 Initializing Cryptographic API Console: switching to colour frame buffer device 128x48 Generic RTC Driver v1.07 Macintosh non-volatile memory driver v1.1 serial8250_init: nothing to do on PowerMac pmac_zilog: 0.6 (Benjamin Herrenschmidt <[EMAIL PROTECTED]>) ttyS0 at MMIO 0x80013020 (irq = 22) is a Z85c30 ESCC - Serial port ttyS1 at MMIO 0x80013000 (irq = 23) is a Z85c30 ESCC - Serial port RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize divert: not allocating divert_blk for non-ethernet device lo MacIO PCI driver attached to Pangea chipset Can't request resource 0 for MacIO device 0.80000000:mac-io input: Macintosh mouse button emulation Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx adb: starting probe task... adb devices: [2]: 2 c4 [3]: 3 1 [7]: 7 1f ADB keyboard at 2, handler 1 Detected ADB keyboard, type ISO, swapping keys. input: ADB keyboard on adb2:2.c4/input input: ADB Powerbook buttons on adb7:7.1f/input ADB mouse at 3, handler set to 4 (trackpad) input: ADB mouse on adb3:3.01/input adb: finished probe task... ide0: Found Apple KeyLargo ATA-4 controller, bus ID 2, irq 19 Probing IDE interface ide0... hda: TOSHIBA MK3018GAS, ATA DISK drive hdb: SONY CD-RW/DVD-ROM CRX820E, ATAPI CD/DVD-ROM drive ide_pmac: Set UDMA timing for mode 2, reg: 0x1090038c hda: Enabling Ultra DMA 2 ide_pmac: Set UDMA timing for mode 2, reg: 0x1090038c hdb: Enabling Ultra DMA 2 Using anticipatory io scheduler ide0 at 0xea0f5000-0xea0f5007,0xea0f5160 on irq 19 mice: PS/2 mouse device common for all mice Found KeyWest i2c on "uni-n", 2 channels, stepping: 4 bits Found KeyWest i2c on "mac-io", 1 channel, stepping: 4 bits NET: Registered protocol family 2 IP: routing cache hash table of 8192 buckets, 64Kbytes TCP: Hash tables configured (established 262144 bind 65536) RAMDISK: cramfs filesystem found at block 0 RAMDISK: Loading 4812 blocks [1 disk] into ram disk... |/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|done. VFS: Mounted root (cramfs filesystem) readonly. Freeing unused kernel memory: 164k init 4k chrp 32k prep NET: Registered protocol family 1 hda: max request size: 128KiB hda: 58605120 sectors (30005 MB), CHS=58140/16/63, UDMA(33) /dev/ide/host0/bus0/target0/lun0: [mac] p1 p2 p3 p4 p5 p6 p7 p8 p9 p10 p11 p12 p13 kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. Unable to find swap-space signature EXT3 FS on hda9, internal journal hdb: ATAPI 24X DVD-ROM CD-R/RW drive, 8192kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.20 orinoco.c 0.13e (David Gibson <[EMAIL PROTECTED]> and others) airport.c 0.13e (Benjamin Herrenschmidt <[EMAIL PROTECTED]>) Airport at physical address 80030000 divert: allocating divert_blk for eth0 eth0: Station identity 001f:0001:0008:0046 eth0: Looks like a Lucent/Agere firmware version 8.70 eth0: Ad-hoc demo mode supported eth0: IEEE standard IBSS ad-hoc mode supported eth0: WEP supported, 104-bit key eth0: MAC address 00:30:65:0E:AF:56 eth0: Station name "HERMES I" eth0: ready airport: card registered for interface eth0 Unable to find swap-space signature ts: Compaq touchscreen protocol output Linux agpgart interface v0.100 (c) Dave Jones agpgart: Detected Apple UniNorth/Pangea chipset agpgart: Maximum main memory to use for agp memory: 565M agpgart: configuring for size idx: 4 agpgart: AGP aperture is 16M @ 0x0 usbcore: registered new driver usbfs usbcore: registered new driver hub ohci_hcd: 2004 Feb 02 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI) ohci_hcd: block sizes: ed 64 td 64 PCI: Enabling device 0001:01:18.0 (0000 -> 0002) ohci_hcd 0001:01:18.0: Apple Computer Inc. KeyLargo/Pangea USB ohci_hcd 0001:01:18.0: irq 27, pci mem ea198000 ohci_hcd 0001:01:18.0: new USB bus registered, assigned bus number 1 hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected PCI: Enabling device 0001:01:19.0 (0000 -> 0002) ohci_hcd 0001:01:19.0: Apple Computer Inc. KeyLargo/Pangea USB (#2) ohci_hcd 0001:01:19.0: irq 28, pci mem ea19a000 ohci_hcd 0001:01:19.0: new USB bus registered, assigned bus number 2 hub 2-0:1.0: USB hub found hub 2-0:1.0: 2 ports detected ieee1394: Initialized config rom entry `ip1394' ohci1394: $Rev: 1223 $ Ben Collins <[EMAIL PROTECTED]> ohci1394: fw-host0: Unexpected PCI resource length of 1000! ohci1394: fw-host0: OHCI-1394 1.0 (PCI): IRQ=[40] MMIO=[f5000000-f50007ff] Max Packet=[2048] sungem.c:v0.98 8/24/03 David S. Miller (davem@redhat.com) divert: allocating divert_blk for eth1 eth1: Sun GEM (PCI) 10/100/1000BaseT Ethernet 00:03:93:da:28:56 PHY ID: 4061e4, addr: 0 eth1: Found BCM5221 PHY ieee1394: Host added: ID:BUS[0-00:1023] GUID[000393fffeda2856] ip1394: $Rev: 1224 $ Ben Collins <[EMAIL PROTECTED]> divert: not allocating divert_blk for non-ethernet device eth2 ip1394: eth2: IEEE-1394 IPv4 over 1394 Ethernet (fw-host0) NET: Registered protocol family 17 eth1: Link is up at 100 Mbps, full-duplex. eth1: Pause is disabled eth1: Link is up at 100 Mbps, full-duplex. eth1: Pause is disabled NET: Registered protocol family 10 Disabled Privacy Extensions on device c0236384(lo) IPv6 over IPv4 tunneling driver divert: not allocating divert_blk for non-ethernet device sit0 hda: Set PIO timing for mode 0, reg: 0x1090032b [drm] Initialized radeon 1.11.0 20020828 on minor 0: ATI Technologies Inc Radeon Mobility M7 LW [Radeon Mobility 7500] agpgart: Putting AGP V2 device at 0000:00:0b.0 into 1x mode agpgart: Putting AGP V2 device at 0000:00:10.0 into 1x mode eth1: no IPv6 routers present
