Your message dated Sun, 27 Feb 2022 11:57:42 -0800 (PST) with message-id <[email protected]> and subject line Closing this bug (BTS maintenance for src:linux bugs) has caused the Debian Bug report #762791, regarding RealTek RTL-8169 driver incapable of changing advertised speed without including duplex setting to be marked as done.
This means that you claim that the problem has been dealt with. If this is not the case it is now your responsibility to reopen the Bug report if necessary, and/or fix the problem forthwith. (NB: If you are a system administrator and have no idea what this message is talking about, this may indicate a serious mail system misconfiguration somewhere. Please contact [email protected] immediately.) -- 762791: https://bugs.debian.org/cgi-bin/bugreport.cgi?bug=762791 Debian Bug Tracking System Contact [email protected] with problems
--- Begin Message ---Package: laptop-mode-tools Version: 1.65-2 Severity: normal Dear Maintainer, from some morning, when I boot my laptop I have a lot of lines like Sep 25 08:10:06 hpdv5 laptop-mode: Laptop mode Sep 25 08:10:06 hpdv5 laptop-mode: enabled, not active Sep 25 08:10:06 hpdv5 kernel: [ 76.966266] r8169 0000:03:00.0 eth0: rtl_phyar_cond == 1 (loop: 20, delay: 25). Sep 25 08:10:06 hpdv5 kernel: [ 76.967192] r8169 0000:03:00.0 eth0: rtl_phyar_cond == 1 (loop: 20, delay: 25). Sep 25 08:10:06 hpdv5 kernel: [ 76.967963] r8169 0000:03:00.0 eth0: rtl_phyar_cond == 1 (loop: 20, delay: 25). Sep 25 08:10:06 hpdv5 kernel: [ 76.968742] r8169 0000:03:00.0 eth0: rtl_phyar_cond == 1 (loop: 20, delay: 25). Sep 25 08:10:06 hpdv5 avahi-daemon[2365]: Joining mDNS multicast group on interface eth0.IPv4 with address 192.168.1.40. Sep 25 08:10:06 hpdv5 avahi-daemon[2365]: New relevant interface eth0.IPv4 for mDNS. Sep 25 08:10:06 hpdv5 avahi-daemon[2365]: Registering new address record for 192.168.1.40 on eth0.IPv4. Sep 25 08:10:06 hpdv5 kernel: [ 76.997522] r8169 0000:03:00.0 eth0: link down Sep 25 08:10:06 hpdv5 kernel: [ 76.997613] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready and the led on my router show the link down. This above every few second (the router led blink like Christmas), mainly until I log in into kdm/kde (thanks to knemo?), but sometimes I must restart the network service. Some notice: - I unplug the battery and use the AC with an UPS (I haven't tried with the battery); - I haven't IPv6 on my LAN and I have tried to disable it by sysctl but not resolves; - I use ifupdown + guessnet and I have the same problem if I set eth0 'auto' or 'allow-hotplug'; - If I reboot the laptop, the eth0 runs without problems (and this is a big problem because I must wait next morning to verify any change/solutions). When few days ago I have set CONTROL_ETHERNET from 'auto' to '0', at the morning boot, the eth0 runs ok. Below the eth0 data (with CONTROL_ETHERNET set to 0): 03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 02) Subsystem: Hewlett-Packard Company Device 3603 Flags: bus master, fast devsel, latency 0, IRQ 47 I/O ports at 6000 [size=256] Memory at d4010000 (64-bit, prefetchable) [size=4K] Memory at d4000000 (64-bit, prefetchable) [size=64K] Expansion ROM at dd200000 [disabled] [size=64K] Capabilities: [40] Power Management version 3 Capabilities: [50] MSI: Enable+ Count=1/2 Maskable- 64bit+ Capabilities: [70] Express Endpoint, MSI 01 Capabilities: [b0] MSI-X: Enable- Count=2 Masked- Capabilities: [d0] Vital Product Data Capabilities: [100] Advanced Error Reporting Capabilities: [140] Virtual Channel Capabilities: [160] Device Serial Number 00-00-00-00-00-00-00-00 Kernel driver in use: r8169 ~ <-su> # ethtool eth0 Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Supported pause frame use: No Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Advertised pause frame use: Symmetric Receive-only Advertised auto-negotiation: Yes Link partner advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Link partner advertised pause frame use: Symmetric Receive-only Link partner advertised auto-negotiation: Yes Speed: 1000Mb/s Duplex: Full Port: MII PHYAD: 0 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: d Current message level: 0x00000033 (51) drv probe ifdown ifup Link detected: yes Thanks -- System Information: Debian Release: jessie/sid APT prefers unstable APT policy: (903, 'unstable'), (500, 'testing'), (400, 'stable') Architecture: amd64 (x86_64) Foreign Architectures: i386 Kernel: Linux 3.16-2-amd64 (SMP w/2 CPU cores) Locale: LANG=it_IT.UTF-8, LC_CTYPE=it_IT.UTF-8 (charmap=UTF-8) Shell: /bin/sh linked to /bin/bash Versions of packages laptop-mode-tools depends on: ii lsb-base 4.1+Debian13 ii psmisc 22.21-2 ii util-linux 2.20.1-5.8 Versions of packages laptop-mode-tools recommends: ii ethtool 1:3.16-1 ii hdparm 9.43-1.1 ii net-tools 1.60-26 ii python-qt4 4.11.2+dfsg-1 ii sdparm 1.07-1 ii udev 215-4 ii wireless-tools 30~pre9-8 Versions of packages laptop-mode-tools suggests: ii acpid 1:2.0.23-1 pn hal <none> ii python 2.7.8-1 -- Configuration Files: /etc/laptop-mode/conf.d/ethernet.conf changed: DEBUG=0 CONTROL_ETHERNET=0 BATT_THROTTLE_ETHERNET=0 LM_AC_THROTTLE_ETHERNET=0 NOLM_AC_THROTTLE_ETHERNET=0 THROTTLE_SPEED="slowest" DISABLE_WAKEUP_ON_LAN=1 ETHERNET_DEVICES="eth0" DISABLE_ETHERNET_ON_BATTERY=1 -- no debconf information
--- End Message ---
--- Begin Message ---Hi This bug was filed for a very old kernel or the bug is old itself without resolution. If you can reproduce it with - the current version in unstable/testing - the latest kernel from backports please reopen the bug, see https://www.debian.org/Bugs/server-control for details. Regards, Salvatore
--- End Message ---
