Package: linux-image
Version: 2.6.25-2-686
I tried to create several software raid(md) array's on my Lenny system,
but unfortunately the resync/recovery of the array's hangs like this:
md3 : active raid1 sdb6[2](F) sda6[0]
126953536 blocks [2/1] [U_]
[>....................] recovery = 0.0% (103296/126953536)
finish=634251.2min speed=0K/sec
md4 : active raid6 sdf1[3] sde1[2] sdd1[1] sdc1[0]
976767872 blocks level 6, 64k chunk, algorithm 2 [4/4] [UUUU]
[>....................] resync = 0.2% (1037056/488383936)
finish=289250.7min speed=0K/sec
I also tried a 2.6.25.14 vanilla kernel, which I built myself but this
one suffers from the same problem. Downgrading to Lenny's 2.6.24 kernel,
however, fixes the problem! I guess it should (could?) be fixed
upstream. But at least we want this fixed before the final release of
Lenny, right?
I don't know if it is related to the type of hardware I'm using, here
are the relevant details of my setup:
- Pentium III 500E
- 2x Promise TX4 SATA controller
- 4x Seagate 500Gb SATA disk
- 2x Samsung 640Gb SATA disk
--
Ing. A.C.J. van Amersfoort (Arno)
Department Of Electronics (ELD, k1007)
Huygens Laboratory
Leiden University
P.O. Box 9504
Niels Bohrweg 2
2333 CA Leiden
The Netherlands
----------------------------------------------------------------
Phone : +31-(0)71-527.1894 Fax: +31-(0)71-527.5819
E-mail: [EMAIL PROTECTED]
----------------------------------------------------------------
Arno's (Linux firewall) homepage: http://rocky.eld.leidenuniv.nl
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
