gm c wrote:
I am unable to get wireless working. I think I can get all nessary
iwconfig info entered but ifconfig eth1 up gives me no inet (ip)
address.
Recently, I was getting this kind of problem when trying to use
wpa_supplicant with the ipw2200 driver.
Keep in mind that the ipw2200 driver is in fairly rapid flux. New
versions are coming out every month or so (with the last two versions
coming out within two days of each other). Also keep in mind that
versions 1.0.4 and higher require the latest 2.3 firmware, and that
versions 1.0.5 and higher require the latest ieee802 modules.
I seems like I am not receiving a signal. On my old latop
signal level is not =0 when I iwconfig. I havent the latest driver
but I would think I could get a signal. below is data:
Hmm. Not sure what to tell you other than try the latest drivers, first.
It's nice of you to share your WEP key with the rest of us on the list,
though. :)
eth1 unassociated ESSID:"myessid"
Mode:Managed Channel=0 Access Point: 00:0D:72:D3:48:F1
Bit Rate=0 kb/s Tx-Power=20 dBm
RTS thr:off Fragment thr:off
Encryption key:1271-7235-01 Security mode:open
Lastly, notice that your channel is set to "0". I'm sure what
misconfiguration this indicates in your system, but you shouldn't have 0
for a channel.
- Joe
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
