hello, after upgrading from sarge to etch and switching from kernel 2.6.10 to self-compiled 2.6.19 my wireless cisco card is not working properly, because I need to configure it manually at every reboot: # iwconfig eth2_rename essid "*******" # iwconfig eth2_rename key s:******* Besides, I would like to know a way to change the interface name from "eth2_rename" to a normal "eth2"...(It was configured as "eth1" in sarge and worked flawlessy). I am using the kernel cisco driver and the yenta-socket module in a sony vaio FX-802; the following is what the kernel says at boot-up: airo(): Finished probing for PCI adapters pcmcia: request for exclusive IRQ could not be fulfilled. pcmcia: the driver needs updating to supported shared IRQ lines. airo(eth2): cmd:111 status:7f11 rsp0:2 rsp1:0 rsp2:0 airo(eth2): Doing fast bap_reads airo(eth2): WPA unsupported (only firmware versions 5.30.17 and greater support WPA. Detected 5.02.19) airo(eth2): MAC enabled 0:f:f8:4e:0:43 eth2: index 0x05: , Vpp 5.0, irq 10, io 0x0100-0x013f
I don't know why, but after that ifconfig reports only an "eth2_rename" wireless interface. -- On this laptop no Windows system survives and LINUX POWER reigns UNLIMITED. Successfully Microsoft free since December 2002. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
