Andreas Barth <[email protected]> writes: Hi,
> * Arnaud Patard ([email protected]) [100503 23:57]: >> Andreas Barth <[email protected]> writes: >> > * Arnaud Patard ([email protected]) [100503 19:45]: >> >> Andreas Barth <[email protected]> writes: >> >> hmm... I've an idea of what the problem is but I need more information >> >> to confirm my hypothesis. Do you know what's providing rtc on your >> >> system ? If it's supposed to be driven by the rtc-cmos driver, can you >> >> boot a kernel with RTC_DEBUG, load the rtc-cmos driver and look for >> >> messages from the rtc kernel stuff ? >> > >> > Did so. This ends with: >> > >> > a...@phrixos:~$ sudo modprobe rtc-cmos >> > FATAL: Error inserting rtc_cmos >> > (/lib/modules/2.6.34-rc6aba3/kernel/drivers/rtc/rtc-cmos.ko): No such >> > device >> > a...@phrixos:~$ >> > >> >> ok, so it's not the bug I was thinking of. Your problem is that you >> don't have a rtc_cmos device. The patch below should help. I think it >> should work on your system but this remains to be confirmed. >> Please try again with this patch and look at the logs to check if it's >> making any difference. > > I still get: > FATAL: Error inserting rtc_cmos > (/lib/modules/2.6.34-rc6aba4/kernel/drivers/rtc/rtc-cmos.ko): No such device > > but in syslog, there is now: > May 3 22:57:15 phrixos kernel: [ 33.860000] rtc_cmos: dev (254:0) > May 3 22:57:15 phrixos kernel: [ 33.860000] rtc_cmos rtc_cmos: rtc core: > registered rtc_cmos as rtc0 > May 3 22:57:15 phrixos kernel: [ 33.864000] rtc_cmos rtc_cmos: only 24-hr > BCD mode supported > (these three lines appear once for each try) Great. Much better. You're now seeing the message I was thinking of :) Hopefully, with this new patch applied with the previous, you should finally get your rtc0 device. Please test :) Arnaud
As a follow-up to the thread about rtc support for some loongson 2e/2f boards, this patch tries to address the "REVISIT"/"FIXME" comments about rtc binary mode handling and allow rtc to work with rtc in binary mode. I've also raised the message about 24-h mode not supported to warning otherwise, one may end up with no rtc without any message in the kernel log. Signed-off-by: Arnaud Patard <[email protected]> --- diff --git a/drivers/rtc/rtc-cmos.c b/drivers/rtc/rtc-cmos.c index e9aa814..9d99408 100644 --- a/drivers/rtc/rtc-cmos.c +++ b/drivers/rtc/rtc-cmos.c @@ -238,31 +238,32 @@ static int cmos_read_alarm(struct device *dev, struct rtc_wkalrm *t) rtc_control = CMOS_READ(RTC_CONTROL); spin_unlock_irq(&rtc_lock); - /* REVISIT this assumes PC style usage: always BCD */ - - if (((unsigned)t->time.tm_sec) < 0x60) - t->time.tm_sec = bcd2bin(t->time.tm_sec); - else - t->time.tm_sec = -1; - if (((unsigned)t->time.tm_min) < 0x60) - t->time.tm_min = bcd2bin(t->time.tm_min); - else - t->time.tm_min = -1; - if (((unsigned)t->time.tm_hour) < 0x24) - t->time.tm_hour = bcd2bin(t->time.tm_hour); - else - t->time.tm_hour = -1; - - if (cmos->day_alrm) { - if (((unsigned)t->time.tm_mday) <= 0x31) - t->time.tm_mday = bcd2bin(t->time.tm_mday); + if (!(rtc_control & RTC_DM_BINARY) || RTC_ALWAYS_BCD) { + if (((unsigned)t->time.tm_sec) < 0x60) + t->time.tm_sec = bcd2bin(t->time.tm_sec); else - t->time.tm_mday = -1; - if (cmos->mon_alrm) { - if (((unsigned)t->time.tm_mon) <= 0x12) - t->time.tm_mon = bcd2bin(t->time.tm_mon) - 1; + t->time.tm_sec = -1; + if (((unsigned)t->time.tm_min) < 0x60) + t->time.tm_min = bcd2bin(t->time.tm_min); + else + t->time.tm_min = -1; + if (((unsigned)t->time.tm_hour) < 0x24) + t->time.tm_hour = bcd2bin(t->time.tm_hour); + else + t->time.tm_hour = -1; + + if (cmos->day_alrm) { + if (((unsigned)t->time.tm_mday) <= 0x31) + t->time.tm_mday = bcd2bin(t->time.tm_mday); else - t->time.tm_mon = -1; + t->time.tm_mday = -1; + + if (cmos->mon_alrm) { + if (((unsigned)t->time.tm_mon) <= 0x12) + t->time.tm_mon = bcd2bin(t->time.tm_mon)-1; + else + t->time.tm_mon = -1; + } } } t->time.tm_year = -1; @@ -322,29 +323,26 @@ static void cmos_irq_disable(struct cmos_rtc *cmos, unsigned char mask) static int cmos_set_alarm(struct device *dev, struct rtc_wkalrm *t) { struct cmos_rtc *cmos = dev_get_drvdata(dev); - unsigned char mon, mday, hrs, min, sec; + unsigned char mon, mday, hrs, min, sec, rtc_control; if (!is_valid_irq(cmos->irq)) return -EIO; - /* REVISIT this assumes PC style usage: always BCD */ - - /* Writing 0xff means "don't care" or "match all". */ - mon = t->time.tm_mon + 1; - mon = (mon <= 12) ? bin2bcd(mon) : 0xff; - mday = t->time.tm_mday; - mday = (mday >= 1 && mday <= 31) ? bin2bcd(mday) : 0xff; - hrs = t->time.tm_hour; - hrs = (hrs < 24) ? bin2bcd(hrs) : 0xff; - min = t->time.tm_min; - min = (min < 60) ? bin2bcd(min) : 0xff; - sec = t->time.tm_sec; - sec = (sec < 60) ? bin2bcd(sec) : 0xff; + + rtc_control = CMOS_READ(RTC_CONTROL); + if (!(rtc_control & RTC_DM_BINARY) || RTC_ALWAYS_BCD) { + /* Writing 0xff means "don't care" or "match all". */ + mon = (mon <= 12) ? bin2bcd(mon) : 0xff; + mday = (mday >= 1 && mday <= 31) ? bin2bcd(mday) : 0xff; + hrs = (hrs < 24) ? bin2bcd(hrs) : 0xff; + min = (min < 60) ? bin2bcd(min) : 0xff; + sec = (sec < 60) ? bin2bcd(sec) : 0xff; + } spin_lock_irq(&rtc_lock); @@ -478,7 +476,7 @@ static int cmos_procfs(struct device *dev, struct seq_file *seq) "update_IRQ\t: %s\n" "HPET_emulated\t: %s\n" // "square_wave\t: %s\n" - // "BCD\t\t: %s\n" + "BCD\t\t: %s\n" "DST_enable\t: %s\n" "periodic_freq\t: %d\n" "batt_status\t: %s\n", @@ -486,7 +484,7 @@ static int cmos_procfs(struct device *dev, struct seq_file *seq) (rtc_control & RTC_UIE) ? "yes" : "no", is_hpet_enabled() ? "yes" : "no", // (rtc_control & RTC_SQWE) ? "yes" : "no", - // (rtc_control & RTC_DM_BINARY) ? "no" : "yes", + (rtc_control & RTC_DM_BINARY) ? "no" : "yes", (rtc_control & RTC_DST_EN) ? "yes" : "no", cmos->rtc->irq_freq, (valid & RTC_VRT) ? "okay" : "dead"); @@ -749,12 +747,11 @@ cmos_do_probe(struct device *dev, struct resource *ports, int rtc_irq) spin_unlock_irq(&rtc_lock); - /* FIXME teach the alarm code how to handle binary mode; + /* FIXME: * <asm-generic/rtc.h> doesn't know 12-hour mode either. */ - if (is_valid_irq(rtc_irq) && - (!(rtc_control & RTC_24H) || (rtc_control & (RTC_DM_BINARY)))) { - dev_dbg(dev, "only 24-hr BCD mode supported\n"); + if (is_valid_irq(rtc_irq) && !(rtc_control & RTC_24H)) { + dev_warn(dev, "only 24-hr supported\n"); retval = -ENXIO; goto cleanup1; }
