hi all, I have been trying to set up a decent config to run X on a Studio Display. I can get a 1280x1024 resolution by changing the hsync and vsync values as follow:
Section "Monitor" Identifier "Generic Monitor" #HorizSync 28-50 #VertRefresh 43-75 # needs larger values for apple studio display HorizSync 28-70 VertRefresh 43-120 Option "DPMS" EndSection but i couldn't get the largest resolution (1400x1050) to work. adding "1400x1050" to the Modes line, along with Virtual 1400 1050, i get a gray screen. if i increase the freqs any more, X starts but the screen goes gray again. here are some of the relevant lines in Xfree86.0.log: (II) NV(0): Not using mode "1600x1200" (no mode of this name) (II) NV(0): Not using default mode "1400x1050" (width too large for virtual size) (--) NV(0): Virtual size is 1280x1024 (pitch 1280) (**) NV(0): *Default mode "1280x1024": 108.0 MHz, 64.0 kHz, 60.0 Hz lspci says this about the card: 0000:f0:10.0 VGA compatible controller: nVidia Corporation NV34 [GeForce FX 5200 Ultra] (rev a1) any one had more success? thanks, paul -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]