Hello, i am getting really tiered installing Debian(Woody or Sarge) on this little Bastard Box called 7025-F50.... Right now i got Debian Sarge installer booting... How this work !! I create an iso cd with the content of ftp://ftp.debian.org/debian/dists/sarge/main/installer-powerpc/current/images/powerpc/cdrom/ in it... also i create a /etc/ dir with yaboot.conf at the root of the cd an i put yaboot from ftp://cdimage.debian.org/pub/cdimage-testing/sarge_d-i/powerpc/current/sarge-powerpc-netinst.iso at the root of the cd. Then i boot the Box ... Pressing F8 to get the OF Prompt then make a boot cdrom:,\yaboot right now i can boot the 2.4/vmlinux from directory above... because the 2.6 vmlinux does not work with the symbios scsi controller in the box. Ok the debian-installer boot, i have to cahnge the cd (put sarge-powerpc-netinst.iso) in the drive.... Everything works fine the Partitioner came up (not really a good thing i missed cfdisk) .. and the system begin a Base system installation. Until the Error the bootloader was not configured correct (during kernel-image-2.4.27-pmac install) ... Ok i skiped to installing without bootloader but the same thing it can't install the kernel-image
Any hints ?? I am really tired with this Box... -- Mit freundlichem Gruß, Best regards, Helfrich Markus ____________________________________________________ Dipl. Inf. (FH) Markus Helfrich Fachhochschule Kaiserslautern Standort Zweibrücken University of applied Science Amerikastr. 1 66482 Zweibrücken Tel.: +49 6332 914 154 Fax.: +49 6332 914 155 mailto: [EMAIL PROTECTED] PGP KeyID 0xD8E95B7C _____________________________________________________