On Friday 26 August 2005 08:44, Ralph wrote:
> Hi !
>
> As I finally do have my 7043-260 up and running with
> kernel 2.6.11 power3 smp, I went to try to build my
> own kernel. Needless to say: not very successfull.
> Although I did (as one can read in lots of howtos) configure
> all the important modules to drive my disk as mandatory, the
> new created kernel does always the same when it should do
> something different, as the log of my good old kernel shows.
> Must be something with initrd/cramfs/ramdisk, when i interpret
> the logfiles in the right way...
> (see logs below)
>
> What am I doing wrong ?
It looks like you're not including the correct SCSI driver:
Make sure that "SYM53C8XX" under "SCSI low-level drivers" is turned on,
as well as "SCSI disk support". I'd compile those into the kernel
("Y") instead of as modules, just to be safe.
Pat
--
Purdue University ITAP/RCS --- http://www.itap.purdue.edu/rcs/
The Computer Refuge --- http://computer-refuge.org
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
