Thanks to Igmar, I can now build a custom kernel (Sparc64) for my Ultra 60.
Unfortunately, I have not been able to figure out how to boot it. I install the kernel in /boot and run silo, but when I boot I get this: Sun Ultra 60 UPA/PCI (2 X UltraSPARC-II 450MHz), No Keyboard OpenBoot 3.17, 2048 MB memory installed, Serial #11419681. Ethernet address 8:0:20:ae:40:21, Host ID: 80ae4021. Rebooting with command: boot Boot device: disk File and args: SILO Version 1.4.4 \ Linux debian 2.4.18 #2 Thu Apr 11 14:37:17 EDT 2002 sparc64 GNU/Linux The programs included with the Debian GNU/Linux system are free software; the exact distribution terms for each program are described in the individual files in /usr/share/doc/*/copyright. Debian GNU/Linux comes with ABSOLUTELY NO WARRANTY, to the extent permitted by applicable law. boot: Allocated 8 Megs of memory at 0x40000000 for kernel Cannot find /vmlinuz (Unknown ext2 error) Image not found.... try again boot: /boot/vmlinuz-2.4.25 Allocated 8 Megs of memory at 0x40000000 for kernel Cannot find /boot/vmlinuz-2.4.25 (Unknown ext2 error) Image not found.... try again boot: /boot/vmlinux-2.4.25 Allocated 8 Megs of memory at 0x40000000 for kernel Cannot find /boot/vmlinux-2.4.25 (Unknown ext2 error) Image not found.... try again boot: I have tried booting a compressed (vmlinuz-2.4.25) and uncompressed (vmlinux-2.4.25) kernel. I am running the latest of everything (unstable). /boot is an ext3 partition, and I have compiled in ext3 support (in kernel, not module). Ideas? Any suggestions would be greatly appreciated. Thanks, <> Jim