On 3/31/2006 3:44 AM, Gary Parker wrote: > Admar Schoonen wrote: > >>>FYI, the U5 has the same openprom as the U10. The 'setenv output-device >>>screen' command only affects the Creator3D card (if yopu have one) in an >>>U10 and has no effect on the output of the VGA ATI display adapter on >>>either the U5 or U10. >> > >>Wrong. You can change the default resolution at the open boot prompt, as >>documented at >>http://040.digital-bless.com/texts/Unofficial_Sun_Blade_100_FAQ.htm >>(search for output-device on that page). According to that page, 1152 x 900 at >>76 Hz is the default resolution. > > > I respectfully beg to differ. That may be the case for Blade100's but my > Ultra10 flatly refused to display anything from OBP on a TFT I have and > no amount of fiddling with the output-device settings fixed it. Once > booted into Linux, however, fbset allowed me to set it up properly and > get a prefectly usable 1024x768x60 display. Whether this behaviour is > specific to a certain revision of OBP or not I don't know, ymmv. > > Gary
I have Creator 3D in my Ultra 10. I am running it with 1280x1024x67 on my LCD. I booted Solaris via the serial console then ran ffbconfig to find out all combination of supported resolution/frequency. That is the only one works on my LCD. Perhaps, you might want to find out what your hardware is capable of before you can change your setting. Alex -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]