try "Protocol" instead of Protocal
roland
Ilia Lobsanov wrote:
Have you tried restarting X?
ilia.
On Thu, 2002-01-24 at 12:45, McNeill Kirkpatrick wrote:
It's still not moving
here is the mouse section from my XF86Config-4 file
Section "InputDevice"
Identifier "Configured Mouse"
Driver "mouse"
Option "Device" "/dev/input/mice"
Option "Protocal" "ImPS/2"
Option "Emulate3Buttons" "true"
Option "ZAxisMapping" "4 5"
EndSection
I just installed usbmgr, and it seems to work
output when I unplug and plug in the mouse:
usb.c: USB disconnect on device 4
hub.c: USB new device connect on bus1/2, assigned device number 5
usb.c: USB device 5 (vend/prod 0x46d/0xc002) is not claimed by any
active driver.
I am pretty sure I compiled usb-uhci directly into the kernel, yet the
mouse just won't move, with either gpm or with X.
On Thu, 2002-01-24 at 11:17, Ilia Lobsanov wrote:
Check if you have usb-uhci module loaded... and install usbmgr.
ilia.
On Thu, 2002-01-24 at 11:53, McNeill Kirkpatrick wrote:
Ok, I'm running sid and I'm trying to get it to recognize my usb mouse,
I recompiled my kernel(2.4.17) with input core support for mice, I had
to run MAKEDEV input manually, that created the /dev/input/mice. When I
use this device however, X starts fine,(no cannot access device errors)
but I cannot move the mouse. It just sits in the middle of the
screen.Any suggestions?
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
