Hi there, i attached the template.
Meanwhile I will try to install "woody" again and update to "sarge". Is there an other method of installing a "sarge"? The old installer worked perfekt for me. Thanks a lot for a great OS, guys. Matthias Stache stellv. Webmaster BUNTE.T-Online.de whow.de STARnetONE GmbH Ein Unternehmen der Hubert Burda Media Kulturbrauerei Prenzlauer Berg Schönhauser Allee 37, Haus V 10435 Berlin Tel: 030/440378-84 Fax: 030/440378-99 e-mail: [EMAIL PROTECTED] www.bunte.t-online.de www.whow.de
Debian installation report template Please use this template when filling out installation reports, and file the report as a bug report against the "installation-reports" pseudo package. INSTALL REPORT Debian-installer-version: 07.06.2003 from ftp (sorry, forgot source) uname -a: 2.4.18 Date: 15.06.2003 Method: First i tried the CD1 of the set. It didn't worked (error messages getting some udeb packages). Then i tried the local-di-sarge.iso. This worked better. More at the bottom... Machine: Custom machine Processor: 586 Pentium 1 at 166Mhz Memory: 96MB RAM Root Device: IDE (hdb1) Root Size/partition table: /dev/hda1 with 100 MB mounted on /boot /dev/hda2 with about 900 MB mounted on /usr /dev/hdb1 with 1200 MB mounted on / /dev/sda1 with 128MB mounted on swap /dev/sda2 with 900 MB mounted on /usr/lib SCSI is NCR85XX C (normally the sym85XX module worked) Output of lspci: [X] i did not tried this Base System Installation Checklist: Initial boot worked: [O] Configure network HW: [ ] Config network: [ ] Detect CD: [O] Load installer modules: [E] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [O] Reboot: [O] [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Comments/Problems: Installation process description: --------------------------------- First i tried the CD1 of the set. Booting was ok, starting the installer too. But loading the installer modules failed with some "error getting XXX.XXX (udeb)" things. I gave up using this method after 3 hours of playing around. After that i downloaded the local-di.iso. Everthing went fine (It detected all my hardware, mounting and installing went ok). Boot Process: ------------- Scsi-Devices not detected. Only one (dhb1) of my two IDE drives mounted (detected all, but only one is mounted)
